User manual PARKSIDE PDFP 500 A1 MANUAL 4

[. . . ] Air paint spray gun PDFP 500 A1 Vent Lid of the gravity flow cup Gravity flow cup Stroke stop screw (paint quantity regulation) Regulator for round/broad jet Compressed air connection Regulator for air quantity control Trigger Nozzle head Nozzle Installation spanner Needle Brush Before initial use please acquaint yourself with the functions of the compressed air paint spray gun and learn about the correct handling of compressed air paint spray guns. Please read the following operating instructions. This compressed air-operated device is only intended for the application / spraying of solvent-containing and water-dilutable paints, glazes, primers, varnishes, automotive topcoats, stains, wood preservatives, pesticides, oils and disinfectants. The device is not suitable for working with dispersion and latex paints, alkalis, acidic coating materials, granular and particulate spraying material or injection and non-drip materials. [. . . ] Do not spray or clean with materials with a flashpoint below 21°C. Do not spray in the area of ignition sources such as static electricity sparks, open flames, pilot lights, hot objects, motors, cigarettes and sparks from inserting and disconnecting power cords or the operation of switches. such sources of sparks can lead to ignition of the surrounding area. Do not spray any materials for which it is not known whether they pose a danger. Unknown materials can create dangerous conditions. Wear additional personal protective equipment such as appropriate protective gloves and protective masks or respirators when spraying or handling chemicals. the wearing of protective equipment in such conditions reduces exposure to harmful substances. Do not spray on yourself, other people or animals. Keep hands and other body parts away from the spray jet. If the spray penetrates the skin, seek medical help immediately. The material being sprayed can even penetrate the skin through a glove and be injected into your body. Working Instructions: - When working with the device you should open the vent 1 . - When diluting the material, make sure that the spraying material and the dilution are suitable for one another. If an incorrect dilution is used, lumps may form and clog the gun as a result. - Screw the flow cup 3 clockwise firmly on to the gun. - Fill the spraying material into the flow cup 3 and screw the lid 2 on tight. - Always hold the paint spray gun at the same distance from the object. - Do not turn the device on / off when it is over the spraying surface, but start and end the spraying process approximately 10 cm outside of the spraying area. Note: The front locking screw is used to limit the adjustment range of the stroke stop screw 4 . In order to do this, open the air volume Increasing the air quantity: Note: Increasing the amount of air is generally advisable when the degree of atomization is too coarse. turn the air quantity regulator 7 in an anticlockwise direction. Reducing the air quantity: Note: Reducing the amount of air is generally advisable when the paint spray is too strong. [. . . ] , as they undergo chemi-cal reactions with some materials in the paint spray gun. This can lead to dangerous reactions CAUTION!Never place the paint spray gun completely in solvent. After every use spray thinner (only in the open air ­ danger of explosion! [. . . ]