User manual PARKSIDE PDSS A1

[. . . ] We will not accept liability for loss or damage arising from improper use. The device is intended for private domestic use only. Sound pressure level: 86 dB(A) Sound power level: 98 dB(A) Values determined in accordance with EN 14462 (EN1953/A1:2009). This will ensure that the compressed air supply hose does not wave around or recoil in an uncontrolled manner. [. . . ] Check the air pressure with a suitable manometer after filling. rISK OF FIRE , EXPLOSION AND DAMAGE TO HEALTH!The device must be used in well-ventilated areas only. Never exceed the maximum allowable working air pressure of 8 bar. Use a pressure reducer to set the working air pressure. High working pressures can give rise to recoil forces that under certain conditions can result in danger from continuous loading. Never point the device at people or animals. Never use oxygen or other combustible gas as the energy source. First disconnect the hose from the compressed air source and only then disconnect the compressed air supply The use of accessories other than those recommended in the operating instructions could lead to you being in danger of injury. Using accessories: j ress the lever of the valve connector 5 and P insert the desired accessory 10 to 13 or the cap 9 into the valve connector 5 . NOTE: Operate the product only with cleaned, condensate- and oil-free compressed air and never exceed the maximum working air pressure at the device of 8 bar. NOTE: The compressed air source must be fitted with a (filter) / pressure reducer so that the air pressure can be regulated. Read off the filling pressure on the gauge 1 . If the object is overfilled with air (air pressure too high): Press the deflator valve 3 to release some air. Press the lever of the valve connector 5 downwards and pull the valve connector 5 off the valve. After you finish work, disconnect the device from the compressor. NOTE: First disconnect the hose from the compressor and only then disconnect the compressed air supply hose from the device. This will ensure that the compressed air supply hose does not wave around in an uncontrolled manner. Screw an extension nozzle 8 on to the blow gun 7 . After you finish work, disconnect the device from the compressor. NOTE: First disconnect the hose from the compressor and only then disconnect the compressed air supply hose from the device. This will ensure that the compressed air supply hose does not wave around in an uncontrolled manner. [. . . ] Only in this way can a post-free despatch for your goods be assured. The warranty covers only claims for material and maufacturing defects, but not for transport damage, for wearing parts or for damage to fragile components, e. This product is for private use only and is not intended for commercial use. The warranty is void in the case of abusive and improper handling, use of force and internal tampering not carried out by our authorized service branch. [. . . ]