User manual PARKSIDE PGG 15 A1 MANUAL 6

[. . . ] Risk of loss of life by electric shock from damaged mains lead or mains plug!Wear hearing protection, dust protection mask, protective glasses and protective gloves. Please make sure you familiarise yourself fully with the way the device works before you use it for the first time and that you understand how to handle electrical power tools correctly. To help you do this please read the accompanying operating instructions. [. . . ] This can result in a much lower vibration load over the whole of the period of working. E) When working outdoors with an electrical power tool always use extension cables that are also approved General safety advice for electrical power tools for use outdoors. The use of an extension cable suitable for outdoor use reduces the risk of electric shock. Use a residual current device (RCD) for protection if operating the electrical power tool in a moist environment is unavoidable. The use of an RCD reduces the risk of electric shock. A) Remain alert at all times, watch what you are doing and always proceed with caution. Do not use the device if you are tired or under the influence of drugs, alcohol or medication. One moment of carelessness when using the device can lead to serious injury. B) Wear personal protective equipment and always wear safety glasses. The wearing of personal protective equipment such as dust masks, non-slip safety shoes, safety helmets or ear protectors, appropriate to the type of electrical power tool used and work undertaken, reduces the risk of injury. c) Avoid unintentional operation of the device. Check for any parts that are broken or damaged enough to detrimentally affect the functioning of the device. Have damaged parts repaired before you use the device. Many accidents have their origins in poorly maintained electrical power tools. Carefully maintained cutting tools with sharp cutting edges are less likely to jam and are easier to control. g) Use the electrical power tool , accessories , inserted tools etc. In accordance with these instructions and advice, and the stipulations drawn up for this particular type of device. In doing this, take into account the working conditions and the task in hand. The use of electrical power tools for purposes other than those intended can lead to dangerous situations. Never use the device for a purpose for which it was not intended or with non-original parts / accessories. The use of tools or accessories other than those recommended in the operating instructions could lead to you suffering an injury. Turn the switch for the number of strokes 2 in the + direction to increase the penetration depth. [. . . ] Using very light pressure, guide the engraving point 5 over the workpiece. Find the ideal speed of movement by trial and error on a piece of waste material. Note: The engraving point 5 supplied with the product is made from carbide steel. Therefore it is not suitable for engraving electronic media such as CDs, DVDs etc. [. . . ]