User manual PARKSIDE PHP 500 A1 MANUAL 6

[. . . ] If you pass the tool on to anyone else, please ensure that you also pass on all the documentation. 1 2 3 4 5 6 7 8 9 10 11 © Proper use © Included items The device is intended for gluing wood, cardboard, packaging, PVC, carpet, seals, plastic, leather, ceramic, glass and textiles with hot-melt adhesive. The material to be glued must be clean, dry and free of grease. Any other use or modification to the tool shall be considered as improper use and could give rise to considerable dangers. The manufacturer will not accept liability for loss or damage arising from improper use. [. . . ] Keep other people and animals away from the hot glue. On contact with the skin, hold the affected part under running cold water for several minutes. Do not try to remove the glue from the skin. © © Operation Before first use 4. Careful handling and use of electrical power tools a) Pull the mains plug from the socket before you make any adjustments to the device, change accessories or when the device is put away. This precaution is intended to prevent you from unintentionally starting the device. b) When not in use always ensure that electrical power tools are kept out of reach of children. Do not let anyone use the device if he or she is not familiar with it or has not read the instructions and advice. Electrical power tools are dangerous when they are used by inexperienced people. Let the device cool down completely before putting it away. Check that moving parts are working properly and move freely. Check for any parts that are broken or damaged enough to detrimentally affect the functioning of the device. Have damaged parts repaired before you use the device. Many accidents have their origins in poorly maintained electrical power tools. d) Always work with the mains lead leading away from the rear of the device. Preparing the glue site: ½ Do not use inflammable solvents to clean the glue site. ½ The ambient temperature and temperature of the materials to be glued must be not less than + 5° C and not warmer than + 50° C. ½ The glue sites must be clean, dry and free of grease. Smooth surfaces should be roughened before gluing. Warm any materials that are prone to cool down quickly (e. g. steel) to improve the bond with the glue. Screw on the appropriate nozzle 8 and fit the wire stand 6 . © Preparing the tool for use Working with the mains lead connected: 1. Connect the mains lead 11 to the glue gun connection 10 (see Fig. Insert the mains plug into the mains socket. [. . . ] Repairs made after the expiration of the warranty period are subject to payment. GB DES UK LTD Tel. : 0871 5000 700 (£ 0. 10 / minute) e-mail: support. uk@kompernass. com GB/IE 9 ½ Heat up the device for about 4 minutes. Touch the nozzle 8 only by the heat shield 9 . The nozzle tip is hot! © Maintenance and Cleaning The glue gun is maintenance-free. [. . . ]