User manual PARKSIDE PHS 160 A1 MANUAL 7

[. . . ] Risk of loss of life by electric shock from damaged mains lead or mains plug!Wear hearing protection, dust protection mask, protective glasses and protective gloves. We will not accept liability for loss or damage arising from improper use. Keep children away from electrical power tools! [. . . ] G) If vacuum dust extraction and collection devices are fitted do not forget to check that they are properly connected and correctly used. The use of these devices reduces the hazard presented by dust. Careful handling and use of electrical power tools 3. personal safety A) Remain alert at all times, watch what you are doing and always proceed with caution. Do not use the device if you are tired or under the influence of drugs, alcohol or medication. One moment of carelessness when using the device can lead to serious injury. B) Wear personal protective equipment and always wear safety glasses. The wearing of personal protective equipment such as dust masks, non-slip safety shoes, safety helmets or ear protectors, appropriate to the type of electrical power tool used and work undertaken, reduces the risk of injury. Always use an electrical power tool that is intended for the task you are undertaking. By using the right electrical power tool for the job you will work more safely and achieve a better result. B) Do not use an electrical power tool if its switch is defective. Ensure that there is adequate ventilation when working on plastic, paint, varnish etc. Do not soak the materials or the surface you are about to work on with liquids containing solvents. do not abrade moistened materials or damp surfaces. Avoid sanding paints containing lead or other substances hazardous to health. Avoid contact with the moving sanding sheet. operate the device only with an attached sanding sheet. Never use the device for a purpose for which it was not intended nor with non-original parts / accessories. The use of tools or accessories other than those recommended in the operating instructions could lead to you suffering an injury. Switch the device off and allow it to come to a standstill before you put it down. Always keep the device clean, dry and free of oil or grease. Make sure that the device is switched off before you connect it to the mains supply. [. . . ] Clean the sanding sheet from time to time with a vacuum cleaner. Sand difficult to reach places with the front or side corners of the backing plate 7 . work in parallel and overlapping widths. After sanding the workpiece, lift the device from the workpiece before switching it off. [. . . ]