User manual PARKSIDE PLBS 30 A1

[. . . ] the device is not intended for commercial use. Any other use or modification to the device shall be considered as improper use and could give rise to considerable dangers. The manufacturer will not accept liability for loss or damage arising from improper use. Failure to observe the instructions and advice given below may result in electric shock, fire and/or serious injury. [. . . ] Always wash your hands immediately after soldering . Do not dispose of soldering waste with the household rubbish. Soldering waste must disposed of as special waste. Careful handling and use of electrical power tools A) When not in use always ensure that electrical power tools are kept out of reach of children. Do not let anyone use the device if he or she is not familiar with it or has not read the instructions and advice. Electrical power tools are dangerous when they are used by inexperienced people. Check for broken parts or parts that are damaged to the extent they detrimentally affect the functioning of the device. Have any damaged parts repaired before you use the device. Many accidents have their origins in poorly maintained electrical tools. Safety advice / Before first use The use of attachments or accessories other than those recommended here could lead to you suffering an injury. Insert the narrower end of the helical spring 3 into the opening of the multifunctional holder 7 . Push the helical spring 3 into the opening as far as it will go. Turn the helical spring 3 clockwise to fix the multifunctional holder 7 in place. Allow the soldering pencil to heat up without a soldering tip. Removal of a soldering tip 2 or a copper attachment 9 10 11 may only be done when the appliance has been switched off and the soldering tip or attachment has cooled down. All soldering tips and attachments have a screw thread and can, therefore, be easily and quickly replaced on the soldering pencil 1 . turn the soldering tip or attachment anti-clockwise to remove it. Turn the soldering tip or attachment clockwise to fix it in place. Switching off: Pull the plug out of the mains socket to switch off the device. The clips on the third hand 5 can become hot while you are soldering the workpiece. Rotate the clips 4 until they are oriented in the required direction. Clamp the workpiece between the two clips 4 . [. . . ] this applies also to replaced and repaired parts. Any damage and defects extant on purchase must be reported immediately after unpacking the appliance, at the latest, two days after the purchase date. Repairs made after the expiration of the warranty period are subject to payment. Do not dispose of electrical devices with the household rubbish! [. . . ]