User manual PARKSIDE PLS 48 B1

[. . . ] Before reading, unfold the page containing the illustrations and familiarise yourself with all functions of the device. Careful handling and use of electrical power tools . The following pictograms are used in these operating instructions / on the device: Read instruction manual!Volt (AC) Watts (Effective power) Wear a breathing / dust mask, protective glasses, gloves and clothing. [. . . ] Always wash your hands immediately after soldering. Do not dispose of soldering waste with the household rubbish. Soldering waste must disposed of as special waste. Careful handling and use of electrical power tools A) When not in use always ensure that electrical power tools are kept out of reach of children. Do not let any one use the device if he or she is not familiar with it or has not read the instructions and advice. Electrical power tools are dangerous when they are used by inexperienced people. Check for broken parts or parts that are damaged to the extent they detrimentally affect the functioning of the device. Have any damaged parts repaired before you use the device. Many accidents have their origins in poorly maintained electrical tools. Safety advice / Before first use The use of attachments or accessories other than those recommended here could lead to you suffering an injury. Allow the soldering pencil to heat up without a soldering tip. Remove a soldering tip only when the device has been switched off and the soldering tip has cooled. Turn the soldering tip out to replace it. Thinly coat with solder, the soldering tip 7 before using the soldering station for the first time and before using a new soldering tip. To do this follow these steps: Insert the mains plug into a mains socket and press the ON / OFF switch 2 into position "I". Turn the temperature regulator 6 to 3 and allow a little solder to flow and deposit a thin continuous film over the surface of the soldering tip. Using the product Switching on / off and setting the temperature Switching on and setting the temperature: Insert the mains plug into a mains socket and press the ON / OFF switch 2 into position "I". Turn the temperature control 6 to set the temperature you wish to have. Problems will occur during soldering if an unsuitable solder wire used. the right soldering temperature must be achieved to produce perfect soldering. [. . . ] In no circumstances use sharp objects, or petrol, solvents or cleaning agents that might attack plastic. Do not allow any liquids to enter the inside of the device. Have your device repaired only by qualified specialist personnel using original manufacturer parts only. This will ensure that your device remains safe to use. [. . . ]