User manual PARKSIDE PSBM 1100

[. . . ] The manufacturer will not accept liability for loss or damage arising from improper use. Your safety Please make sure you familiarise yourself fully with the way the tool works before you use it for the first time and that you understand how to handle electrical power tools correctly. Further details can be found in the operating instructions. In addition to the above, you must also observe the general safety advice contained in the accompanying booklet. [. . . ] Pull the plug out of the mains socket immediately and have the device repaired by a suitably qualified person or at your service centre. J Do not operate the device if it is damp and do not use it in a damp environment. J If you use the device outdoors, always connect it through a residual current device (RCD) with a maximum trip current of 30 mA. If using an extension lead, always use one that is approved for outdoor use. J Do not use the device in rain or in wet conditions. J o not work in areas where there may be D hidden electricity cables or gas or water pipes. Use a suitable detector or ask your local utility service providers. Contact with electricity cables can lead to fire or electric shock. Damaging a gas pipe can lead to an explosion. Penetration 8 GB/IE of a water pipe can lead to property damage or to electric shock. To avoid the risk of injury: Wear protective glasses, hearing protection (noise can lead to hearing loss), dust protection mask and protective gloves. Please note that working on stone or metal can give rise to hazardous dusts that can adversely affect your health. J e particularly careful when screwing in longer B screws - the driver could slip off the screw head. J se the auxiliary handle supplied with the device. U Loss of control of the tool can lead to injury. Use clamps or S a vice to grip the workpiece firmly. This is much safer than holding it in your hand and it means you then have both hands free to operate the electrical power tool. J J J J J If a dangerous situation arises, pull the mains plug immediately out of the mains socket. [. . . ] j o not allow any liquids to enter the device. j o not under any circumstances use petrol or D strong solvents. The gear selector switch must only be moved after the drill has come to a standstill. [. . . ]