User manual PARKSIDE PSS 260

[. . . ] Please read the operating instructions below and the accompanying safety advice !Use the equipment only as described and for the indicated purposes. By doing this you will be able to work in complete safety and produce better results. We hope you enjoy using your sander. FEATURES OF THE PSS 260 Clip Sanding sheet Base Air vents Dust bag adapter Paper dust bag TECHNICAL INFORMATION Nominal power: Low load speed: 260 W no 7, 000 ­ 11, 000/min Nominal voltage: 230 V ~ 50 Hz Dust extraction system: built-in extraction system / or with exterior suction device Weight: 2. 25 kg , Handle ON / OFF switch Adjuster wheel Continuous operation locking button Dust extraction nozzle (Fig. ) , , = accessories supplied Orbits: max. [. . . ] Make sure that the sanding sheet is tight against the base. - The holes in the sanding sheet and the base must align for the dust to be extracted through the base. Different materials need different grades of sanding sheets. To determine which grade is suitable for your work, please read our recommendation in Tips and Tricks. DUST EXTRACTION · DUST EXTRACTION WITH PAPER DUST BAG Push the paper dust bag on to the adapter . Ensure that the adapter fits correctly into the holder. Clip the dust bag with the adapter to the side of the sander. · DUST EXTRACTION WITH VACUUM CLEANER For dust extraction using a vacuum cleaner use the appropriate connector ­ see Figure . Attach the adapter to the end of the vacuum cleaner hose and clip it to the side of the equipment. 5 MAINTENANCE OF THE ORBITAL SANDER 1. For the best results do this straight after the work has been completed. Do not allow liquids to get inside the sander. Use a soft cloth for cleaning the housing. Do not use petrol, solvents or cleaners that may attack the plastic. Air vents must always be clear and clean. ADVICE ON WORKING METHODS, TIPS AND TRICKS You can use the PSS 260 orbital sander for effortless sanding even on large areas, see Fig. Move the orbital sander in parallel broad circles or in alternate longitudinal and transverse directions. This damages the sanding sheets and adversely affects sanding performance. From time to time clean the sanding sheet with a vacuum cleaner. You do not have to resand any areas when working up to edges. The orbital sander works right into the corners because its housing is continuous with the edge of the sanding sheet, see Fig. · The integrated dust extraction system allows you to work cleanly overhead. Use the integrated dust extraction system or your vacuum cleaner wherever possible when sanding. · The choice of speed and grade of sanding sheet determines the sanding performance and therefore the results of your work. [. . . ] Further practical tips for power tools can be found in the accompanying booklet on safety advice. We reserve the right to make technical modifications in the course of further development. 6 STATEMENT OF CONFORMITY We, Kompernaß Handelsgesellschaft mbH, Burgstr. 21, D-44867 Bochum, Germany, hereby declare that this product conforms with the following EC regulations: EC low voltage regulations: Electromagnetic compatibility: Applicable harmonised standards: (98/37 EWG) (73/23/EEG), (93/68 EEG) (89/336 EEG), (92/31 EEG), (93/68 EEG) EN 50144-1:1998 EN 50144-2-4:1995 EN 55014-1:1993+A1 EN 61000-3-2:1995+A1+A2 EN 61000-3-3:1995 EN 55014-2:1997 Type: PSS 260 Bochum, 30. 06. 2002 Hans Kompernaß - Managing Director - 7 WARRANTY This piece of equipment is covered by a 36-month warranty as of the date of purchase. The equipment was produced with the greatest of care and underwent thorough testing before delivery. [. . . ]