User manual PARKSIDE PTBM 500

[. . . ] Before you begin reading this information, please unfold the page with the illustrations and familiarize yourself with all functions of the tool. Page 27 Safety advice relating specifically to this device . The following icons / symbols are used in this instruction manual: Read instruction manual!Wear dust protection mask, protective glasses and protective gloves. [. . . ] J Before the electrical power tool is used any further, carefully check the safety equipment and any slightly damaged parts to see that they are still working properly. J Check that all moving parts on the tool are working properly, can move freely and are not damaged. All parts must be correctly attached and fulfil all the requirements necessary to allow the electrical power tool to operate properly. J Damaged safety equipment and components must be properly repaired or replaced at a competent electrical equipment repair centre unless otherwise indicated in the operating instructions. j Damaged switches must be replaced at a Customer Service Centre. J Never use an electrical power tool that cannot be switched on and off properly. J The use of inserted tools and accessories other than those recommended by the manufacturer could lead to you being injured. Have your electrical power tool repaired at an electrical equipment repair specialist. J This electrical power tool complies with the relevant safety regulations. Repairs may only be carried out by a specialist electrical repair centre using original spare parts, otherwise injury could occur to the user. J are properly fixed in place and seated. Check that the interlock switch 29 under the drive / belt cover 6 is working properly: The bench press drill must switch off automatically when the drive / belt cover 6 is opened. Never remove drilling debris with your hand. Failure to observe this advice may lead to injury. Do not wear gloves whilst working with the bench press drill. Failure to observe this advice may lead to the gloves becoming wound around the revolving parts. Be aware that persons operating the device or in its vicinity may be at risk of being in contact with or inhaling dusts. Take all the necessary safety precautions in relation to dusts. mixtures of materials can be particularly dangerous. Light metal alloy dust, for example, may burn or explode. Machining metal can result in electrically conductive dust being deposited inside the device. Operate the device through a residual current device (RCD) with a trip current of 30 mA. [. . . ] Open the drive / belt cover 6 and unscrew the fixing screw 11. The speed is set by simply repositioning the V-belts 28. The depth stop with its scale 12 allows you set the device to drill to an exact depth. j Release the clamp bolt 16 of the drilling table 19. [. . . ]