User manual PARKSIDE PTBM 350-13

[. . . ] Always check that all safety devices are attached and properly fixed in place. Always check that the workpiece is firmly and securely clamped in place. Never drill a workpiece whilst holding it in your hands. [. . . ] Fix the drill vice ´ (4 drill vice screws ¿) on to the drilling table ». Place the pre-assembled motor unit ¶ on to the column. The motor unit is attached by two hexagonal socket screws on the right hand side. Attach the three armed handle/spindle control in the rise and fall shaft. Attach the chuck ¾ firmly to the drill spindle cone. Attention: Clean the drill spindle cone thoroughly to remove all traces of grease. SETTING UP THE MACHINE Set the bench drill down on a firm surface and level it using a spirit level. We recommend that the machine is bolted down on to the supporting surface. Please ensure that the base plate ³ is not subject to any additional forces as a result of being bolted down. 5 INSTALLATION AND FIRST USE Check that the supply type, voltage and fuses comply with those specified for the machine. First clean any anti-rust coating carefully from the parts. Then oil the column. SWITCHING THE MACHINE ON AND OFF Insert the plug into the mains socket and switch on the machine using the "I" button at the on/off switch º. To switch off use the "0" button. CHECKING AND TENSIONING THE V-BELT Open the drive/belt cover ¸ and check the V-belt tension. If it is correctly adjusted the V-belt should be able to be moved approximately 1 cm in the middle between the two drive wheels. Loosen the adjustment screw and press the motor unit ¶ backwards before retightening the adjustment screw . SETTING THE SPEED The bench drill has 5 different speeds. The speed is set by simply repositioning the V-belt. To do this open the drive/belt cover ¸, loosen the adjustment screw and place the V-belt on the relevant pair of drive wheels. Note: The top pair give the highest speed; the bottom pair the lowest ( =2600, = 1750, = 1250, = 900, = 600, see figure on page 3). Then tension the V-belt as described in the section on "Tensioning the V-belt". Note: Inside the drive/belt cover ¸ there is a contact which must come together with an opposing contact (see ) on the drive/belt casing base when the drive cover is closed. [. . . ] 21, D-44867 Bochum, Germany, declare that this product complies with the following EU directives: Machinery Directive (98/37 EC), Low Voltage Directive (73/23 EEC, 93/68 EEC), Electromagnetic Compatibility (89/336 EEC, 93/68 EEC) in accordance with the applicable standards, and confirm this with the CE mark. Type/machine description: PARKSIDE BENCH DRILL PTBM 350-13 Bochum, 31. 08. 02 Hans Kompernaß - Managing Director - 7 WARRANTY This piece of equipment is covered by a 36-month warranty as of the date of purchase. The equipment was produced with the greatest of care and underwent thorough testing before delivery. [. . . ]