User manual PARKSIDE PWS 1100

[. . . ] After this is reached, the IPC system speed control mode keeps the grinder operating at a constant speed. The IPC electronic system mode sees to it that, when working under load, the grinder cannot inadvertently become overloaded. If the grinder's nominal performance rating is reached or exceeded during use, the IPC electronic system signals to you with additional power pulses that there is an overload. These power pulses become more pronounced with increasing overload. 4 If the overloading of the grinder is increased further in spite of these warnings, the IPC electronic system activates an integrated current limiter, which restricts the overloading of the power tool by setting a maximum operating current of 11 A. [. . . ] Do not press the sides against anything to slow it down more quickly. · Always keep the power cable well out of the grinder's working area and fed to the rear of the machine. OPERATION 1. The voltage must agree with that shown on the identification plate (equipment shown as 230 V can also be used with 220 V). It should not be damaged, wet or cracked. As a safety measure, run the angle grinder for about 30 seconds under no load. Look out for any unusual noises or sparking. Then check that all the components are correctly attached. The PWS 1100 angle grinder is fitted with a specially designed switch for increased safety. TO SWITCH ON: TO SWITCH OFF: slide the ON/OFF switch forwards gently press the ON/OFF switch backwards Warning: Only use the spindle lock when the electric motor has come to a standstill. 5 SETTING THE SPEED You can set the required speed / rpm using the speed control wheel to suit your work. You can also change the speed whilst you are working. A practical test before you start can help you to determine the most appropriate speed to use. To increase the speed (rotation), turn the speed control wheel towards 6 (6 = highest speed). To decrease the speed (rotation), turn the speed control wheel towards 1 (1 = lowest speed). CHANGING THE GRINDING DISC Note: Only use discs that are free of contaminants, as indicated in "Important safety advice". Isolate the tool from the electrical power supply by pulling the plug from the socket. Press the spindle lock to block the drive. Remove the clamping nut using the wrench. Once the grinding disc has been changed retighten the clamping nut . Warning: If after replacement, the grinding disc runs erratically or vibrates, it must be changed immediately. AUXILIARY HANDLE Warning: For your safety, only use the grinder with the auxiliary handle fitted. The auxiliary handle can be fitted to the left or right hand side of the grinding head to suit your way of working. MAINTENANCE OF THE ANGLE GRINDER 1. For the best results do this straight after the work has been completed. Do not allow liquids to get inside the grinder. Use a soft cloth for cleaning the housing. [. . . ] 1 = These accessories are not supplied with the angle grinder. Further practical tips for power tools can be found in the accompanying booklet on safety advice. We reserve the right to make technical modifications in the course of further development. STATEMENT OF CONFORMITY We, Kompernaß Handelsgesellschaft mbH, Burgstr. 21, D-44867 Bochum, hereby declare that this product conforms with the following EC regulations: (98/37 EEC) (73/23/EEC), (93/68 EEC) (89/336 EEC), EN 50144-1:1998; DIN VDE 0740 Teil 21:1994 EN 55014-1:1993 +A1 +A2; EN 61000-3-2:1995 +A1 +A2; EN 61000-3-3:1995 EN 55014-2:1997 EC low voltage regulations: Electromagnetic compatibility: Applicable harmonised standards: Manufacturer: Model type: Description: PARKSIDE PWS 1100 ANGLE GRINDER Bochum, 30. 09. 2002 Hans Kompernaß - Managing Director - 7 WARRANTY This piece of equipment is covered by a 36-month warranty as of the date of purchase. The equipment was produced with the greatest of care and underwent thorough testing before delivery. [. . . ]