User manual PARKSIDE PWS 30 SE

[. . . ] Before reading, unfold both pages containing illustrations and familiarise yourself with all functions of the device. General safety advice for electrical power tools Careful handling and use of electrical power tools. Page Further special safety advice for disc-cutting . Page Special safety advice for abrading using sandpaper . [. . . ] Never attempt to pull the still rotating cutting disc out of the cut as this could cause kickback. Allow the cutting disc to reach full speed before carefully continuing with the cut. Otherwise the disc could snag, jump out of the workpiece or cause a kickback. e) Support boards or workpieces whilst cutting to reduce the risk of kickback caused by a jammed cutting disc. Large workpieces may bend under their own weight. The workpiece must be supported to both sides of the cutting disc and particularly near the cutting disc and at the workpiece edge. F) Be particularly careful when pocket cutting in existing walls or other areas where you cannot see what you are cutting into. The cutting disc plunged into the surface could cut through gas or water pipes, electricity cables or other objects and cause kickback. General safety advice for electrical power tools Special safety advice for abrading using sandpaper Sanding sheets that project beyond the backing pad could cause injury in addition to jamming, tearing of the sheet or kickback. Special safety advice for polishing Has any loose parts, in particular the fastening cords. tuck the fastening cords away or trim them. Loose fastening cords rotating with the attachment could catch your fingers or become trapped in the workpiece. Special safety advice for working with wire brushes A) Bear in mind that wire brushes lose pieces of wire during normal use. Do not overload the wires by applying too much pressure. Flying pieces of wire can very easily penetrate thin clothing and / or skin. B) Use a guard, if recommended, but make sure that the wire brush does not come into contact with the guard. The diameters of disc brushes and cup brushes can increase due to contact pressure and centripetal forces. Do not touch the mains lead if it becomes damaged or cut through while you are using the device. Pull the plug out of The mains socket immediately and have the device repaired by a suitably qualified person or at your service centre. Do not operate the device if it is damp and do not use it in a damp environment. If you use the device outdoors, always connect it through a residual current device (RCD) with a maximum trip current of 30 mA. If using an extension lead, always use one that is approved for outdoor use. [. . . ] Ventilation openings must always be kept free. Remove any adhering dust with a narrow paint brush. The warranty for this appliance is for 3 years from the date of purchase. The appliance has been manufactured with care and meticulously examined before delivery. [. . . ]