User manual PARKSIDE XQ2

[. . . ] Technical information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page Page Page Page Page 6 6 6 6 6 Safety Safety advice relating to this specific tool . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 6 Operation Switching on and off . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Vacuum dust extraction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] To avoid the danger of injury, burning and damage to health: mDanger of fire from flying sparks!Be aware that persons operating the W tool or in its vicinity may be at risk of being in contact with or inhaling dusts. Take all the necessary safety precautions in relation to dusts. Working with this tool can give rise to dusts that may be hazardous to health, inflammable or explosive. Harmful or poisonous dusts can, for example, arise from sanding paints containing lead, or from certain types of hardwoods or metals. Wear a breathing mask and use a suitable dust / chip vacuum extraction device. W Mixtures of materials can be particularly dangerous. Light metal dust, for example, may burn or explode. J hen sanding wood and in particular when W working on materials that give rise to dusts that are hazardous to health, the sander must be connected to a suitable external dust extraction device. J Wear protective glasses, hearing protection, dust protection masks and protective gloves. J nsure that there is adequate ventilation when E working on plastic, paint, varnish etc. J void sanding paints containing lead or other A substances hazardous to health. J Do not sand any material containing asbestos. J irmly support the workpiece (in a clamp or vice) F unless its own weight is enough to keep it in place. J Avoid contact with the moving sanding belt. J perate the tool only with an attached sanding O sheet. J o not abrade moistened materials or damp D surfaces. Proper procedure and handling: J ever use the tool for a purpose for which it was N not intended nor with non-original parts / accessories. J lways switch on the device before placing it A against the workpiece. After abrading, lift the device from the workpiece before switching it off. J hen working always hold the device securely W with both hands. J llow the device to come to a complete standstill A and switch it off before you put it down. J hen taking a break from your work, before W carrying out any tasks on the device itself (e. g. [. . . ] Suck out the debris carefully with a vacuum cleaner using a low suction pressure. j lean the tool and remove any adhering dust C with a narrow paint brush. j ever any kind of sharp object or petrol, solvents N or cleaning agents that might attack plastic. Do not allow any liquids to enter the inside of the tool. [. . . ]