User manual PEAVEY CEQ 28R

[. . . ] A 7-band, two-and-one-half-octave graphic equalizer that provides 15 dB of boost or cut at each center frequency. Adjusting this control will only affect signals at the High Range Output Jack and the Low Range Output Jack on the rear panel. All other output signals are unaffected by this control. The LED is green when the power switch is in the "on" position. [. . . ] Provides ground to be made from the line out jack or lifted to eliminate ground loop from unit and external source. There may be some situations when audible hum and/or noise will come from the loudspeaker. Select the ground switch to either the in or out position to minimize the noise. Used to connect line level signal to the power amplifier. The preamp output can be used to route the amplified signal to a mixing console, tape recorder, etc. connect the preamp output using a shielded cable to an input of the tape recorder , mixer , etc. This patch does not affect the operation of the amplifier. Signal level is adjusted by the master volume control and the crossover balance control. Signal level is adjusted by the master volume control and the crossover balance control. Selects the effects loop operating level: -10 dBV (3 V RMS) when in low position and 0 dBV (1 V RMS) when in high position. 200 W RMS into 8 ohms 350 W RMS into 4 ohms 500 W RMS into 2 ohms Greater than 95 dB below rated power 35 dB from input jack, -20 dB from full range output (-10 dB Pad Out) Post EQ: -7 dB nominal, +15. Such purchase price will be that in effect for the specific product when the cause of action arose. This limitation of liability will not apply to claims for personal injury or damage to real property or tangible personal property allegedly caused by Peavey's negligence. Peavey does not assume liability for personal injury or property damage arising out of or caused by a non-Peavey alteration or attachment, nor does Peavey assume any responsbility for damage to interconnected non-Peavey equipment that may result from the normal functioning and maintenance of the Peavey equipment. In the event of any modification or disclaimer of expressed or implied warranties, or any limitation of remedies, contained herein conflicts with applicable law, then such modification, disclaimer or limitation, as the case may be, shall be deemed to be modified to the extent necessary to comply with such law. Your remedies for breach of these warranties are limited to those remedies provided herein and Peavey Electronics Corporation gives this limited warranty only with respect to equipment purchased in the United States of America. In the event warranty service is required during the warranty period, you will need this document. There will be no identification card issued by Peavey Electronics Corporation. Completion and mailing of WARRANTY REGISTRATION CARDS -- Should notification become necessary for any condition that may require correction, the REGISTRATION CARD will help ensure that you are contacted and properly notified. Notice of address changes ­ If you move from the address shown on the WARRANTY REGISTRATION CARD, you should notify Peavey of the change of address so as to facilitate your receipt of any bulletins or other forms of notification which may become necessary in connection with any condition that may require dissemination of information or correction. WARNING: When using electric products, basic cautions should always be followed, including the following. Read all safety and operating instructions before using this product. [. . . ] Care should be taken so that objects do not fall and liquids are not spilled into the unit through the ventilation holes or any other openings. This unit should be checked by a qualified service technician if: a. Anything has fallen or been spilled into the unit. The unit has been dropped or the enclosure damaged. [. . . ]