User manual PEAVEY CEX-4LA

[. . . ] Congratulations on the purchase of your CEX-4LATM Series monitor console. the CEX-4LATM utilizes the latest in low-noise circuitry and surface mount technology. In addition, Peavey's exclusive Feedback Locating System (FLS ®) can be found at each channel and at the two tunable notch filters. The result is a quiet, flexible monitor mixer packed with features. [. . . ] Master Monitor Faders: These 100mm Faders control the overall monitor mix level found at the Monitor Outputs (#4 and #5). No signal is heard until either AFL (#13) or PFL (#41) is selected on an active Master Monitor output. If both AFL and PFL are selected simultaneously from the same output, the PFL signal will be heard. This includes the PFL level when it is active. This includes the PFL level when it is active. The Wedge Left/Right signals are the same signals found in the headphones. This level control, however, gives you separate control over the Wedge Output level and is not dependent of the Headphone Level control. Master PFL Level/LED: This section adjusts the level of the PFL mix found at the Headphone and Wedge Outputs. A channel's PFL Switch (#41) must be selected in order for the PFL Level control to work. This is indicated by the LED above the Master PFL Level control. If this LED is pulsating off and on then it is a clear indication one of the channel PFL switches are on. This filter has a corner frequency of 75 Hz and is used to eliminate low frequency signal content such as rumble and wind noise. Another advantage of low frequency elimination is the added headroom that you may receive from your monitor amplifiers. The center frequency of this control is adjustable (#30) between 500 Hz and 15 kHz. Hi Mid Shift: Adjusts the center frequency of the High Mid EQ control (#29) within the range of . Low Mid EQ: A bandpass (boost/cut) type of active tone control that varies the low mid frequency levels ±15 dB. The center frequency of this control is adjustable (#32) between 100 Hz and 3 kHz. Low Mid Shift: Adjusts the center frequency of the Low Mid EQ control (#31) within the range of . For each input channel there are ten monitor sends. These monitor sends are numbered and correspond directly to the numbered outputs found in the Master Section. Each channel offers a mute/clip LED and a Signal/PFL LED so you can see, as well as hear, your work. Using the Post Switches (#35), Monitor Sends 1-6 and 7-8 can be split into two separate groups where either group can be selected pre-fader or post. [. . . ] ) This product should be located so that its position does not interfere with its proper ventilation. It should not be placed flat against a wall or placed in a built-in enclosure that will impede the flow of cooling air. This product should not be placed near a source of heat such as a stove, radiator, or another heat producing amplifier. Connect only to a power supply of the type marked on the unit adjacent to the power supply cord. [. . . ]