User manual PEAVEY IP 8.5C DATASHEET

[. . . ] ¥ CABÕs: (CobraNet Audio BoBÕs) Ethernet audio input and output ports and level controls, with control ports for virtually any system control parameter ¥ Comments: a text entry area to type in any type of note or comment for explanation or clarification ¥ Control modifiers to limit the range of controls ¥ Crossover Networks: 2-, 3-, and 4way using Bessel, Butterworth, and Linkwitz-Riley filter functions in appropriate slope-rates from 6 dB to 48 dB per octave in 6 dB increments ¥ Delay lines: 5, 50, and 200 ms, plus 3D position calculating delays, from 1 to 16 outputs ¥ Diagnostics for the system (compiled-in) ¥ Diagnostics for the system (noncompiled) ¥ Dip panels: a graphic object for a control area, label, message, etc. ¥ Dynamics: AGCÕs, compressors, duckers, expanders, GAP Ambient Level Sensorsª, noise gates, and limiters ¥ Equalization filters: all-pass filters, band-pass filters, CD horn lift, graphic EQÕs, high-pass filters, lowpass filters, parametric filter sets, shelving filters, and tone controls ¥ Error indicators for digital errors ¥ Hardware failure indicators ¥ Labels: graphic areas to type in any type of label, banner, etc. ¥ Level controls: attenuators with and without trim control (limits); crossfaders; distribution amplifiers with 2 to 16 outputs; multi-channel attenuator groups from 2 to 16 channels; On-Off switches; panning attenuators from 2 to 5 channels; ramps with adjustable ramp level change, ramp time, and ramp rate DIGITAL ELECTRONICS SPECIFICATIONS System Controller Board: Pentium II SBC (single board computer), or equivalent, or better Processor: Pentium II 350 MHz, or equivalent, or better Cache: 512 kilobytes or more Memory: 64 megabyte or more PC-100 RAM Drives: ¥ 3. 5" 1. 44 megabyte floppy disk drive ¥ 32X CD ROM ¥ 4. 2 gigabyte hard disk drive Video Board: True color PCI video with 4 megabyte of video RAM and select able resolution from 640 x 480 to 1, 600 x 1, 200, plus refresh rates from 43 Hz to 200 Hz. The system is shipped set for 800 x 600 at 75 Hz. Network Interface Board: 10/100BaseT fast Ethernet board with RJ-45 connector Digital Audio Processing Boards: Digital Audio I/O: 32 channels in / 32 channels out per DPU board for all DPU board types Processors: Four Motorola 56002 DSP chips per board Digital Audio Bussing: 256 inter-board channels (between DPU boards), 256 inter-cell channels (between DSP chips) ¥ Logic controls: Boolean with 2, 4, or 8 inputs RPN: base integer RPN, base logic RPN, base % RPN, control inverter, dual flip-flop, event counter, or flipflop functions ¥ Meters: LED with tiny and large signal-presence or overload indication, Peak and RMS meters in 4 appearances with parameter controls ¥ Mixers from 2 to 64 inputs and from 1 to 16 outputs ¥ Presets: up to 25 system-wide with more possible ¥ Program launchers to launch other programs from within MWare 3. 0 ¥ RoomLinkª room combiners, using either automixers, mixers, or mixers with delay, for 3 to 15 rooms ¥ Routers: from 1 to 32 inputs and from 1 to 32 outputs, with or without ¥ Processor preconfigurations for 4 Peavey speaker systems ¥ Sub-presets: up to 25 for individual child windows with more possible and schedulable with a built-in event timer System mute to mute all outputs simultaneously ¥ Test functions: DC-voltage generator, frequency-response probe, I/O probe, pink-noise generator, signal probe, sine-wave generator, and a white-noise generator ¥ Title blocks: a graphic area to type in any type of title, etc. [. . . ] (2) Any control parameters of any of the above devices may be controlled via the control ports on the BoB or CAB I/Os, and via third-party control software with a properly configured interface port. Backplane: 14-slot passive backplane with (4) PCI slots and (10) ISA slots, (PIC/MG CPU slot for easy board swapping) GENERAL SPECIFICATIONS Controls: Front door lock Keyboard lock System power switch Reset and Power LEDs Power Switch, Power and HDD LEDs Chassis slide rails SOFTWARE SPECIFICATIONS Operating System: Microsoft Windows NT 4. 0 for system controller board MWare 3. 0 for sound system design, control, and diagnostics (operates under Microsoft NT 4. 0) 2 Connectors: Front panel: (1) AT keyboard connector and (1) PS2 mouse connector Rear panel: (1) Euro-style AC cord connector, (1) DB-25 parallel connector, (1) PS2 keyboard connector, (1) PS2 mouse connector(1) DB-15 video connector, and (2) COM port DB-9 connectors (COM 1 and COM 2) Dimensions: 6. 97" H x 19" W x 19. 30" D (17. 70 cm H x 46. 26 cm W x 49. 02 cm D) Note: a 24"-deep rack is required. control, and hardware platform that requires only microphones, microphone preamps, power amplifiers, and speakers to provide a complete and working system. It shall be based on an open architecture that utilizes a modular computer mainframe including a power supply, a floppy-disk drive, a CD ROM drive, a system controller board, and up to four digital signal processing boards. The MM-760nt Mainframe system shall provide all needed line-level signal processing for up to 128 audio input lines and 128 audio output lines. Systems of lesser capacity shall not be acceptable. The MM-760nt Mainframe systemÕs CPU shall be Intel Pentium II-based, or equivalent, or better and the userÕs control and design interface GUI shall be PeaveyÕs MWare 3. 0 running under Microsoft Windows NT 4. 0. The MM-760nt Mainframe systemÕs software must provide the ability to design, wire, operate, control, and troubleshoot a complete digital audio system in the software domain. It shall allow the creation of custom control panels and devices to provide unique solutions not possible on other DSP audio platforms. Additionally, it shall allow third-party control of virtually any adjustable parameter in the system design. Systems not providing the above capabilities and not operating under Microsoft Windows NT 4. 0Õs robust and stable operating system shall not be acceptable. The MM-760nt Mainframe shall accommodate three types of DPU boards: digital audio boards accommodating A/D and D/A converted signals, AES/EBU standard digital audio signal boards; and digital audio boards for CobraNet bridges to Ethernet networked audio paths. (18. 63 kg) AC Power: 400-Watt PS/2 universal power supply, UL, CSA, and CE listed Voltage: 100 to 120/200 to 240 VAC +/-10%, auto-selecting depending on source voltage Frequency: 50 to 60 Hz +/-5% Maximum Power Consumption and Heat Generation: 920 Watts, 3128 BTU/Hr. at 115 VAC fully loaded 1150 Watts, 3910 BTU/Hr. at 230 VAC fully loaded Maximum In-rush Current: 80A at 115 VAC, 40A at 230 VAC, 25o C cold start Finish: Grey powder-coat painted steel Accessories: ¥ Detachable AC cord ¥ Rack slides ¥ Keys for front door, keyboard, and mouse ¥ Microsoft Windows NT 4. 0 CD ¥ Pentium II, or equivalent, or better SBC manual ¥ Drivers for the 100BaseT fast Ethernet board and PCI video board Product Agency Compliance Listings: UL, CUL, CE, and FCC part 15, A ARCHITECTÕS AND ENGINEERÕS SPECIFICATIONS The MediaMatrix MM-760nt Mainframe signal processor shall be a softwarebased, integrated sound system design, 3 ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ appropriate slope-rates from 6 dB to 48 dB per octave in 6 dB increments Delay lines: 5, 50, and 200 ms, plus 3D position calculating delays, from 1 to 16 outputs Diagnostics for the system (compiled-in) Diagnostics for the system (noncompiled) Dip panels: a graphic object for a control area, label, message, etc. (2) Any control parameters of any of the above devices may be controlled via the control ports on the BoB or CAB I/Os, and via third-party control software with a properly configured interface port. Other software packages not offering the stability, security or flexibility of these operating system and design/control/ diagnostics packages shall not be acceptable. The MM-760nt Mainframe system shall have the following front-panel controls and connectors: Front door and keyboard locks, system power and reset switches; power and HDD LEDs; AT keyboard and PS2 mouse connectors. On the rear panel, it shall have a Euro-style AC cord connector, a DB-25 parallel connector, a PS2 keyboard connector, a PS2 mouse connector a DB-15 video connector, and two COM port DB-9 connectors for COM 1 and COM 2. The MM-760nt Mainframe shall have a 400-Watt PS/2 universal power supply, UL, CSA, and CE listed. It shall operate on AC power at either 50 or 60 Hz +/- 5%, from 100 to 120 VAC or 200 to 240 VAC +/-10% auto-selecting depending on the source voltage. The power supply shall consume no more than 920 Watts and produce no more than 3128 BTU/Hr. [. . . ] at 115 VAC fully loaded, or consume no more than 1150 Watts and produce no more than 3910 BTU/Hr. It shall draw a maximum in-rush current of no more than 80A at 115 VAC and no more than 40 A at 230 VAC. The MM-760nt Mainframe shall be 6. 97" (17. 70 cm) high by 19" (46. 26 cm) wide by 19. 03" (49. 02cm) deep and requires a 24"-deep rack. It shall be finished in grey powder-coat painted steel. [. . . ]