User manual PEAVEY IPA 300

[. . . ] ¥ Dynamics: AGCÕs, compressors, duckers, expanders, GAP Ambient Level Sensorsª, noise gates, and limiters ¥ Equalization filters: all-pass filters, band-pass filters, CD horn lift, graphic EQÕs, high-pass filters, lowpass filters, parametric filter sets, shelving filters, and tone controls ¥ Error indicators for digital errors ¥ Hardware failure indicators ¥ Labels: graphic areas to type in any type of label, banner, etc. ¥ Level controls: attenuators with and without trim control (limits); crossfaders; distribution amplifiers with 2 to 16 outputs; multi-channel attenuator groups from 2 to 16 channels; On-Off switches; panning attenuators from 2 to 5 channels; ramps with adjustable ramp level change, ramp time, and ramp rate ¥ Logic controls: Boolean with 2, 4, or 8 inputs RPN: base integer RPN, base logic RPN, base % RPN, control inverter, dual flip-flop, event counter, or flipflop functions DIGITAL ELECTRONICS SPECIFICATIONS System Controller Board: Pentium MMX SBC (single board computer), or equivalent, or better Processor: Pentium 233 MHz MMX, or equivalent, or better Cache: 512 kilobytes or more Memory: 32 megabytes or more EDO RAM Drives: ¥ 3. 5" 1. 44 megabyte floppy disk drive ¥ 32X CD ROM ¥ 4. 2 gigabyte hard disk drive Video Board: True Color, PCI video board with four megabytes of video RAM and selectable resolutions from 640 x 480 to 1, 600 x 1, 200, plus refresh rates from 43 Hz to 200 Hz. THe system is shipped set for 800 x 600 at 75 Hz. Network Interface Board: 10/100BaseT fast Ethernet board with RJ-45 connector ¥ Meters: LED with tiny and large signal-presence or overload indication, Peak and RMS meters in 4 appearances with parameter controls ¥ Mixers from 2 to 64 inputs and from 1 to 16 outputs ¥ Presets: up to 25 system-wide with more possible ¥ Program launchers to launch other programs from within MWare 3. 0 ¥ RoomLinkª room combiners, using either automixers, mixers, or mixers with delay, for 3 to 15 rooms ¥ Routers: from 1 to 32 inputs and from 1 to 32 outputs, with or without ¥ Processor preconfigurations for 4 Peavey speaker systems ¥ Sub-presets: up to 25 for individual child windows with more possible and schedulable with a built-in event timer System mute to mute all outputs simultaneously ¥ Test functions: DC-voltage generator, frequency-response probe, I/O probe, pink-noise generator, signal probe, sine-wave generator, and a white-noise generator ¥ Title blocks: a graphic area to type in any type of title, etc. ¥ Via function to allow a signal to loop back up the signal chain without creating feedback oscillation ¥ Wave file players for 32, 44. 1, and 48 kHz system sample rates at 100%, 50%, and 25% of that sample rate. [. . . ] ¥ Via function to allow a signal to loop back up the signal chain without creating feedback oscillation ¥ Wave file players for 32, 44. 1, and 48 kHz system sample rates at 100%, 50%, and 25% of that sample rate. Notes: (1) New devices may be created and stored by the user in these libraries (2) Any control parameters of any of the above devices may be controlled via the control ports on the BoB or CAB I/OÕs, and via third-party control software with a properly configured interface port. Digital Audio Processing Boards: Digital Audio I/O: 16 channels in / 16 channels out per DPU board Processors: Four Motorola 56002 DSP chips per board Digital Audio Bussing: 256 inter-board channels (between DPU boards), 256 inter-cell channels (between DSP chips) GENERAL SPECIFICATIONS Controls: ¥ ¥ ¥ ¥ ¥ ¥ Front door lock Keyboard lock System power switch Reset and Power LEDs Power Switch, Power and HDD LEDs Chassis slide rails Backplane: Eight-slot passive backplane with (3) PCI slots and (5) ISA slots, (PIC/MG CPU slot for easy board swapping) SOFTWARE SPECIFICATIONS Operating System: ¥ Microsoft Windows NT 4. 0 for system controller board ¥ Miniframe MWare Lite for sound system design, control, and diagnostics (operates under Microsoft NT 4. 0) Connectors: Front panel: (1) AT keyboard connector and (1) PS2 mouse connector Rear panel: (1) Euro-style AC cord connector, (1) DB-25 parallel connector, (1) At keyboard connector, (1) PS2 mouse connector, and (2) COM port DB-9 connectors (1) DB-15 video connector (COM 1 and COM 2) 2 Dimensions: 6. 97" H x 19" W x 19. 30" D (17. 70 cm H x 46. 26 cm W x 49. 02 cm D) NOTE: A 24"-deep rack is required. Net Weight w/o DPU Boards: 40 lbs. (18. 18 kg) Miniframe 208nt/108nt system shall provide all needed line-level signal processing for up to 32/16 audio input lines and 32/16 audio output lines. Systems of lesser capacity shall not be acceptable. The Miniframe 208nt/108nt systemÕs CPU shall be Intel Pentium MMX-based, or equivalent, or better and the userÕs control and design interface GUI shall be PeaveyÕs Miniframe MWare Lite running under Microsoft Windows NT 4. 0. The Miniframe 208nt/108nt systemÕs software must provide the ability to design, wire, operate, control, and troubleshoot a complete digital audio system in the software domain. It shall allow the creation of custom control panels and devices to provide unique solutions not possible on other DSP audio platforms. Additionally, it shall allow third-party control of virtually any adjustable parameter in the system design. Systems not providing the above capabilities and not operating under Microsoft Windows NT 4. 0Õs robust and stable operating system shall not be acceptable. The Miniframe 208nt/108nt shall accommodate a digital audio board that orperates at 32 kHz, 44. 1 kHz, and 48 kHz A/D and D/A sample rates. ¥ Dynamics: AGCÕs, compressors, duckers, expanders, GAP Ambient Level Sensors, noise gates, and limiters ¥ Equalization filters: all-pass filters, band-pass filters, CD horn lift, graphic EQÕs, high-pass filters, low- AC Power: 320-Watt PS/2 universal power supply, UL, CSA, and CE listed Voltage: 100 to 120/200 to 240 VAC +/10%, auto-selecting depending on source voltage Frequency: 50 to 60 Hz +/-5% Maximum Power Consumption and Heat Generation: 805 Watts, 2737 BTU/Hr. at 115 VAC fully loaded 920 Watts, 3128 BTU/Hr. at 230 VAC fully loaded Maximum In-rush Current: 60A at 115 VAC, 35A at 230 VAC, 25o C cold start Finish: Grey powder-coat painted steel Accessories: ¥ Detachable AC cord ¥ Keys for front door, keyboard, and mouse ¥ Microsoft Windows NT 4. 0 CD ¥ MediaMatrix Miniframe MWare Lite CD ¥ Pentium MMX, or equivalent, or better SBC manual ¥ Drivers for the 10/100BaseT fast Ethernet board and PCI video board Product Agency Compliance Listings: UL, CUL, CE, and FCC part 15, A ARCHITECTÕS AND ENGINEERÕS SPECIFICATIONS The MediaMatrix Miniframe 208nt/108nt signal processor shall be a softwarebased, integrated sound system design, control, and hardware platform that requires only microphones, microphone pre-amps, power amplifiers, and speakers to provide a complete and working system. It shall be based on an open architecture that utilizes a modular computer mainframe including a power supply, a floppy-disk drive, a CD ROM drive, a system controller board, and up to (Miniframe 208nt): two digital signal processing boards/(Miniframe 108nt): one digital signal processing board. The Miniframe 208nt/108nt system shall have the following front-panel controls and connectors: Front door and keyboard locks, system power and reset switches; power and HDD LEDs; AT keyboard and PS2 mouse connectors. On the rear panel, it shall have a Euro-style AC cord connector, a DB-25 parallel connector, an AT keyboard connector, a PS2 mouse connector a DB-15 video connector, and two COM port DB-9 connectors for COM 1 and COM 2. The Miniframe 208nt/108nt shall have a 320-Watt PS/2 universal power supply, UL, CSA, and CE listed. It shall operate on AC power at either 50 or 60 Hz +/-5%, from 100 to 120 VAC or 200 to 240 VAC +/-10% auto-selecting depending on the source voltage. The power supply shall consume no more than 805 Watts and produce no more than 2737 BTU/Hr. at 115 VAC fully loaded, or consume no more than 920 Watts and produce no more than 3128 BTU/Hr. [. . . ] The power supply shall consume no more than 805 Watts and produce no more than 2737 BTU/Hr. at 115 VAC fully loaded, or consume no more than 920 Watts and produce no more than 3128 BTU/Hr. It shall draw a maximum in-rush current of no more than 60A at 115 VAC and no more than 35 A at 230 VAC. The Miniframe 208nt/108nt shall be 6. 97" (17. 70 cm) high by 19" (46. 26 cm) wide by 19. 03" (49. 02cm) deep and requires a 24"-deep rack. [. . . ]