User manual PEAVEY KB5

[. . . ] A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding plug. The wide blade or third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. [. . . ] Connect left output of your keyboard to the left input of the KB5/KB4 and connect right output of your keyboard to the right input of the KB5/KB4 5. Adjust the channel level for proper volume 9. ) Caution: Excessive low frequency boost causes greater power consumption and increases the possibility of speaker damage. Controls the high-impedance microphones or other high-level sources equipped with a 1/4" phone plug. Controls the low-impedance microphones or other low-level sources equipped with a male XLR connector. This affects what signal is sent to the headphones. When in the OUT position, only the signal from channel 5 is sent to the headphones. Great when you need to hear a click track or midi/pre-recorded track. When engaged (IN position), the headphones are sent signals from all channels. Keep in mind, this signal is never sent to the Main XLR outs. Controls high-impedance microphones or other high-level sources equipped with a 1/4" phone plug. This sets the level to the headphone jack on the rear panel. To avoid damage to your hearing, make sure to turn the dial fully counter-clockwise before using headphones. Slowly turn the knob clockwise until a comfortable listening level is set. This knob sets the overall level for the unit. Make sure the Master level is completely down (full counterclockwise) before powering up the unit. This does not affect the headphone level. With this switch in the OUT position, a unique circuit senses signal conditions that might overload the amplifier and activates compression to reduce gain and avoid clipping. This technique utilizes every watt available for the amplifier to reproduce the signal, yet minimizes clipping and distortion which reduces the potential for speaker damage. Since this function is "invisible" at levels below the clipping point, it is advised that it be activated at all times. [. . . ] 100 Watts RMS/4 Ohms or 75 W RMS/8 Ohms with DDT off (1 kHz, 1% THD @ 120 VAC line) Greater than 100 dB below rated power The following preamp specs are measured @ 1 kHz, nominal signal levels are with channel level controls set at 5, minimum levels are with channel level controls set at 10. 200 Watts RMS/4 Ohms or 150 Watts RMS/8 Ohms with DDT off (1 kHz, 1% THD @ 120 VAC line) Greater than 100 dB below rated power The following preamp specs are measured @ 1 kHz, nominal signal levels are with channel level controls set at 5, minimum levels are with channel level controls set at 10. 100 Watts RMS/4 Ohms or 75 W RMS/8 Ohms with DDT off (1 kHz, 1% THD @ 120 VAC line) Greater than 100 dB below rated power What This Warranty Does Not Cover The Warranty does not cover: (1) damage caused by accident, misuse, abuse, improper installation or operation, rental, product modification or neglect; (2) damage occurring during shipment; (3) damage caused by repair or service performed by persons not authorized by Peavey; (4) products on which the serial number has been altered, defaced or removed; (5) products not purchased from an Authorized Peavey Dealer. Who This Warranty Protects This Warranty protects only the original retail purchaser of the product. [. . . ]