User manual PEAVEY LTD ST

[. . . ] All measurements are wideband 20 Hz to 20 kHz unless otherwise stated. All control settings are nominal (50% rotation) unless otherwise noted. Nominal Channel Gain: Low Z = 20 dB Line = 0 dB Output Level: Nom Max = 0 dBV (1. 0 V RMS) = +19 dBV ( 9 V RMS) Minimum Channel Gain: Low Z = -69 dB Line = -89 dB Input Impedance: 10 K ohms Output Impedance: 100 ohms Maximum Channel Gain: Low Z = 40 dB Line = 20 dB MASTER Gain: Main: Monitor: Tape: Aux: Main: Monitor: Tape: Aux: Main: Monitor: Tape: Aux: Main: Monitor: Tape: Aux: = = = = = = = = = = = = = = = = 20 dB 15 dB 15 dB 15 dB +18 dBV (8. 0 V RMS) +18 dBV (8. 0 V RMS) +18 dBV (8. 0 V RMS) +18 dBV (8. 0 V RMS) 18 dB 18 dB 18 dB 18 dB 100 ohms 100 ohms 10 K ohms 100 ohms Nominal Input Level: Low Z = -20 dBV Line = 0 dBV Minimum Input Level: Low Z = -40 dBV Line = -20 dBV Maximum Output Level: Maximum Input Level: Low Z = +6 dB Line = +26 dB Phantom Power: +48 V DC Nominal Headroom: CHANNEL Equivalent Input Noise: -114. 5 dBV @ 40 dB max gain GRAPHIC EQUALIZER: Filter Bandwidth: 1 octave Frequency Response: (to speaker outputs) ±1 dB 20 Hz to 20 kHz Filter Frequencies: (ISO Stds. ) 63 Hz, 125 Hz, 250 Hz, 1 kHz, 2 kHz, 4 kHz, 8 kHz, 16 kHz Output Impedance: Distortion: (1 kHz) Less than . 015% Filter Q: 1. 57 Input Impedance: Low Z Bal = 1. 7 K ohms Line Input = 13 K ohms Maximum Boost & Cut: + 6 dB, -12 dB Output Noise: Residual: -100 dBV (Master Level Down) Bus: -94 dBV (Master Nominal, All Channel Level Full CCW, Aux Returns Down) Nominal: -86 dBV (All Controls Nominal, Low Z Input Terminated 150 ohms) High EQ: ±12 dB @ 10 kHz minimum Center detent flat ±2 dB Noise: -100 dBV Distortion: (1 kHz) Less than . 005% Mid EQ: ±12 dB @ 600 Hz minimum Center detent flat ±2 dB Frequency Response: ±1 dB 7 Hz to 40 kHz Low EQ: ±12 dB @ 50 Hz minimum Center detent flat ±2 dB Input Level: Nom = 0 dBV (1. 0 V RMS) Max = +19 dBV ( 9 V RMS) ® ARCHITECTURAL ACOUSTICS® Aux Input Impedance: 120 K ohms Input Sensitivity: 1 V RMS for 150 watts @ 4 ohms Aux Input Level: Nom: 0 dBV Max: +7 dBV Min: -15 dBV Input Impedance: 19 K ohms Power Requirements: 800 watts, 120 V AC, 60 Hz type input) microphone input as well as a 1/4" line input. [. . . ] The unit features a 150 watt power amplifier. Tape Input Level: Nom: +4 dBV Max: +11 dBV Min: -10 dBV DESCRIPTION The IRMTM 8150 features a rugged, heavy-gauge, cold-rolled steel and aluminum chassis, finished in ovencured epoxy for toughness and screenprinted utilizing the latest photographic film and U. V. -cured ink technology for razor-sharp, hard-wearing control I. D. Every on-board component has been carefully chosen to deliver the highest possible performance. Precision, professional reliability and absolute minimal operating noise characteristics are only among the initial criteria used during the process of selecting the components that ensure that your IRMTM 8150 becomes an indispensable addition to your performance equipment. All printed circuit boards are constructed from rugged, U. S. militaryspec material, using the latest automated assembly technology, wave solder, and computer-controlled "allfaults-analyzed-and-corrected" Q. A. Each channel features front panel main and monitor level controls, as well as high, mid, low equalization and AUX send controls. (Note: Batteries and patch cords not covered. ) "Original purchaser" means the customer for whom the product is originally installed. Damage resulting from improper installation, interconnection of a unit or system of another manufacturer, accident or unreasonable use, neglect or any other cause not arising from defects in material and workmanship is not covered by this warranty. The warranty is valid only as to products purchased and installed in the United States. THIS LIMITED WARRANTY IS IN LIEU OF ANY AND ALL WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR USE. UNDER NO CIRCUMSTANCES WILL PEAVEY BE LIABLE FOR ANY LOST PROFITS, LOST SAVINGS, INCIDENTAL DAMAGES OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE USE OR INABILITY TO USE THE PRODUCT, EVEN IF PEAVEY HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. THIS LIMITED WARRANTY IS THE ONLY EXPRESSED WARRANTY ON THIS PRODUCT, AND NO OTHER STATEMENT, REPRESENTATION, WARRANTY, OR AGREEMENT BY ANY PERSON SHALL BE VALID OR BINDING UPON PEAVEY. [. . . ] Peavey's liability to the original purchaser for damages for any cause whatsoever and regardless of the form of action is limited to the actual damages up to the greater of Five Hundred Dollars ($500) or an amount equal to the purchase price of the product that caused the damage or that is the subject of or is directly related to the cause of action. This limitation of liability will not apply to claims for personal injury or damage to real property or tangible personal property allegedly caused by Peavey's negligence. [. . . ]