User manual PEAVEY PM ONE

[. . . ] PM ONE TM P r o d u c t i o n M i xe r Operating Guide Intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. Intended to alert the user of the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. CAUTION: Risk of electrical shock -- DO NOT OPEN!CAUTION: To reduce the risk of electric shock, do not remove cover. [. . . ] (See diagram on back. ) The Mic 1 Input is a balanced, low impedance controlled by the Microphone Fader (11). The Voice-over Switch (12) can be placed in the TALK position while the Mic 1 Input is active to temporarily drop the music level by 12 dB. MIC 2 INPUT The Mic 2 Input is a balanced, low impedance TRS 1/4" input controlled by the Channel Fader (13) of Channel 4. The Channel Input Select Switch for Channel 4 must be in the MIC 2 position for Mic 2 to be active. The Mic 2 input is located on the rear of the unit (see diagram on Page 4. ) FRONT PANEL 19 21 19 22 14 15 20 13 11 16 24 17 12 18 18 25 23 26 CHANNEL/MIC CONTROLS This section describes the controls which affect the four individual channels and the Mic1/Mic 2 inputs. Refer to the diagram above for physical locations. MICROPHONE FADER This fader controls the level of the MIC 1 Input (9) only. The MIC 2 Input (10) is an optional microphone input placed on Channel 4. Placing the fader in the Ò0Ó position will produce minimum gain or no signal. Moving the fader to the Ò10Ó position will give maximum gain or the highest output signal. VOICE-OVER SWITCH This switch is used to reduce Channels 1-4 by 12 dB. When placed in the OFF position, all channels return to their normal level. Use this switch to punch into your program with vocal material and punch back out to return to music. 6 13. CHANNEL FADER This stereo fader controls the level of each individual channel regardless of input type. Placing the fader in the Ò0Ó position will produce minimum gain or no signal. Moving the fader to the Ò10Ó position will give maximum gain or the highest output. CHANNEL INPUT SELECT SWITCH The inputs on Channels 1 through 4 are controlled by an input selector switch. Each channel has a designated switch that is used to select its input. The optimum position for this control will produce a signal in the 0 dB range, just slightly lighting the red LEDs at the highest peaks. X-FADER This stereo slider delivers crossfade capability between any two input channels (1-4). You will find an X-Fader Assign selector on each side of the X-Fader. These are used to select the two input channels that the X-Fader will crossfade between. [. . . ] Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. If this product is to be mounted in an equipment rack, rear support should be provided. Exposure to extremely high noise levels may cause a permanent hearing loss. Individuals vary considerably in susceptibility to noise-induced hearing loss, but nearly everyone will lose some hearing if exposed to sufficiently intense noise for a sufficient time. [. . . ]