User manual PEAVEY RANGER 212

[. . . ] Pry off the breakaway panel next to the interface connector with a screwdriver Breakaway panel Insert the OkiLAN 6130 by sliding it along the rails in the recess of the printer, until it is plugged into the socket in the rear of the recess. Plug the power cord into the power outlet (if provided). [. . . ] The red and green indicators on the OkiLAN 6130 blink during self-test. When self-test completes successfully, the red indicator goes off and the green indicator stays on. To print configuration information, press and hold the Test button on the front of the OkiLAN 6130 for five seconds. The content of the configuration sheet depends on your printer and system setup. Using PEAVEY's ExtendView Utility to Configure Your IP Address First, download the ExtendView utility from PEAVEY Data's website at http://www. Com ­ navigate to the page for your specific product, then click on Drivers, then Utilities, to locate the software. In the ExtendView utility, highlight the device you are going to configure. From the CD or PEAVEY Data website - follow the installation instructions. entering the Printer IP Address While installing the printer driver for TCP/IP using the CD supplied with your printer. When you come to the screen requesting the IP Address for the printer, you must select "IP Address" (instead of the default "Search address") and type in the printer's IP Address before clicking Next. If you need help, please contact your Network Administrator for the IP Address to use. Make sure there are no error conditions in the printer (e. , paper jam) before you use LPR to discover the printer. Turn on the printer and wait for the print server to boot up (about 30 seconds). [. . . ] Turn on the printer and wait for the print server to boot up (about 30 seconds). The lights will flash briefly after releasing the button, then the card will reset. [. . . ]