User manual PEAVEY REACTOR

[. . . ] If you have a ML390/1T network printer, you can use the applicable ML390/1T Users Manuals and Network Documentation that is included on the CD. The documentation, printer drivers, and network information are provided on the CD-ROM included with the printer. Your printer has a parallel port, a USB (Universal Serial Bus) port, and a network interface (if your printer has a network card). The steps you use to install your printer vary according to your · Two versions are available: a single-bin and a dual bin. [. . . ] You must lift the small door to access the CSF connector. Printers without the USB port have a CSF connector on the back of the printer. The changes are described in this document. The documentation for your printer is provided as a combination of on-line documentation on the CD and hardcopy documentation provided with the printer. The CSF (Cut Sheet Feeder) connector has been moved to the top, back, left-hand corner of the printer. The settings listed below are the changes or additions to those listed in the User's Guide. For a complete explanation of the menu and each menu item, refer to the User's Guide, "Using Your Printer, Menu Mode, Explanations of Menu Items. " The User's Guide is provided as an Adobe Acrobat file on the CD provided with your printer. The table below shows the items that may appear in the menu. Settings which are engaged at the factory (defaults) are set in bold italic. Some groups or entries will only appear when a specific emulation is engaged, as noted. How you set the Top of Form depends on the status of the Forms Tear-Off menu setting. To load single sheets, see your Printer User's Guide, "Installation, Paper Loading. " To load bottom-feed paper, see the instructions provided with the pull/push tractors. to load rear-feed , continuous-forms paper: 1. Grasp the tabs and lift off the paper separator. Wide Carriage Models Microline 321 Turbo/n, Microline 391 Turbo/n If you are using 8. 5 inch paper to run the test, make sure the paper width selection in the printer menu is set to 8. Otherwise, printing on the platen may damage the printer. Run the Font Sample Test to make sure your printer is operating properly. to run the test: · Turn the printer off, then press and hold the LF key while turning the printer back on. Plug the power adapter wire into the power jack on the network card. [. . . ] Some countries may require a different adapter for local voltages, such as 240 VAC. Use the Add Printer wizard, not the menu installer, to install 64-bit drivers: 1. Follow the on-screen instructions to complete the installation. All Printers Installing a printer on a network is best handled by someone familiar with networks (such as a Network Administrator)! [. . . ]