User manual PEAVEY SK76 INSTALLATION

[. . . ] Hold the chassis (top and bottom) tightly and turn the instrument the right way up. Grasp the extreme top ends of the lid and lift it off by following the sequence of illustrations A, B and C. [. . . ] Note: Place two sheets of paper between controls panel and the flanks to avoid their scoring. Model - Modello Instructions / Istruzioni ENGLISH Disconnect the instrument from the mains. carefully turn the instrument over and unscrew the screws marked by the arrows. Hold the chassis (top & Bottom) tightly and turn the instrument the right way up, lift off the top chassis as shown in the figure with care without forcing or disconnecting the cables. B) Be careful do not disconnect the cables. This page is intentionally left blank - Locate the CPU board [A] and remove the support [B] by unscrewing the locking screws [7]. - Fix the mounting brakets [3] to the Hard Disk [6] by means of the four screw [4] and the four washers [5], fix the assembly to the threaded locations [E] by means of the four screws [4] and the four washers [5]. - Connect one end of the jumper [2] to the Hard Disk connector, starting from the extreme left end in order that 4 free pins remain to the right of the connector, and the other end to the CPU's CN8 connector [D]. NOTE: The optional Generalmusic Hard Disk is not supplied with this kit. Hard Disks are avalaible from special outlets with the same technical characteristics as the optional Generalmusic hard disk. If you mount the optional Generalmusic hard disk DO NOT FORMAT THE DEVICE, because it is supplied already formatted and filled with various styles, samples and songs. - Locate the CPU board [A] and remove the support [B] by unscrewing the locking screws [7]. [. . . ] IMPORTANT: if the hard disk is not supplied by Generalmisic, you may FORMAT it following the instructions enclosed in the owner's manual. - Assemble the brackets (C) to the hard disk (B) using the screws (D) and their washers (E). [. . . ]