User manual PEAVEY VOCAL 100

[. . . ] Intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION: To reduce the risk of electric shock, do not remove cover. WARNING: To prevent electrical shock or fire hazard, do not expose this appliance to rain or moisture. Before using this appliance, read the operating guide for further warnings. [. . . ] footswitch LEDs: The LEDs on the footswitch indicate the selected preset: A or b. If the Bypass LED is off, the setting will be A or B depending on which is illuminated. To change between A and B, simply press the A/B switch. to switch to Bypass and override the setting of the A/B switch , press the Bypass override button. When the Bypass LED is lit, the unit is in Bypass mode regardless of the A/B setting. To return to A or b, press Bypass to return to the desired setting. This system is ideal for toggling between two presets and/or bypassing the unit completely. This can be very useful when trying to simulate an analog or tape delay. By adjusting this control to lower settings, the resulting delays will sound warmer, more "analog". By adjusting this control to higher settings, the resulting delays will sound brighter, more "digital". the digital reverb is also tailored by the setting of the DSP Edge control. For more modern sounding, brighter reverbs, the control should be set higher. to more closely approximate a spring reverb , set the control lower. Additional equalization for the delays and reverbs can be obtained by using the programmable EQ, with the delays and reverbs mixed 100% wet and the master Left and Right mix controls to set the mix. This technique allows for the creation of many different sounding reverb effects. The presets are arranged in 20 banks (0-9 of user and 0-9 of factory sets) of 2 patches (A and b) per bank for a total of 40 presets. If the decimal point between the 0 and A illuminates, this signifies that the preset is in the user set and is editable. Getting Into Edit Mode: Editing presets and parameters on the Vocal 100 is quite simple. After using the parameter v or w buttons to select the preset you wish to edit, the next step in editing presets on the Vocal 100 is to put the effects system into Edit mode. This is accomplished by pressing either the v or FX EDIT button. after you do so , the Distortion/Exciter LED will start to blink. To discard the edited changes at any time during the editing process, simply press Play or change the preset using the footswitch. [. . . ] Government's Occupational and Health Administration (OSHA) has specified the following permissible noise level exposures: Duration Per Day In Hours 8 6 4 3 2 1 1/2 1 1/2 1/4 or less Sound Level dBA, Slow Response 90 92 95 97 100 102 105 110 115 According to OSHA, any exposure in excess of the above permissible limits could result in some hearing loss. Ear plugs or protectors to the ear canals or over the ears must be worn when operating this amplification system in order to prevent a permanent hearing loss, if exposure is in excess of the limits as set forth above. To ensure against potentially dangerous exposure to high sound pressure levels, it is recommended that all persons exposed to equipment capable of producing high sound pressure levels such as this amplification system be protected by hearing protectors while this unit is in operation. Slight curve shows a soft knee In Level Use el botón v FX EDIT para escoger el parámetro de centésima y use los botones v w para definirlo. [. . . ]