User manual PEAVEY VSX 26

[. . . ] Intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION: To reduce the risk of electric shock, do not remove cover. WARNING: To prevent electrical shock or fire hazard, this apparatus should not be exposed to rain or moisture, and objects filled with liquids, such as vases, should not be placed on this apparatus. Before using this apparatus, read the operating guide for further warnings. [. . . ] MIC: Allows engaging the +48 V phantom power as well as adjusting the Mic gain range from 23 dB to 67 dB of gain. When Sine is selected the frequency of the sine wave may be adjusted for 20 Hz to 20 kHz. the output level may be adjusted by highlighting the fader graphic and adjusting the Level control. An In/Out button is provided to turn on and off the generator. the screen may be exited by selecting "done" or pressing the "setup button. The Generator must be assigned to an output of your choice with the Matrix. A single B and pass filter can also be assigned to that output and the skirts may be adjusted to provide limited bandwidth noise for testing purposes. mATRIX: The matrix provides the method to assign inputs to outputs. In the default configuration NO SIGNAL IS PASSED through the unit until some selection in the matrix is made. This prevents potentially destructive signals from reaching the wrong outputs. the inputs are represented by the rows and the outputs by the columns. Most users will commonly assign crossovers in the setup screen so that only a single input assignment will be necessary. In addition to the line inputs the RTA and GEN inputs are assigned in this screen. To continue from the matrix you must exit from the upper left or the lower right squares. SETUP: Selecting this button takes you to the preset configuration page. The VSXTM is pre-programmed with eight configuration templates representing the most frequently used crossover possibilities. As you scroll through the configuration presets you will see and can adjust the basic filter types (only symmetrical choices may be made here). Center frequencies of those filters and a graphic representation of the filters will be displayed. You must enter "OK" to accept the selection. selecting and pressing Exit or pressing the Setup button will return you to the main screen. Upon returning to the main screen you will see the graphic representation of your selection. OUTPUT 1-6: Output levels may be adjusted on this page. [. . . ] The user is free to mix and match filter types to create symmetrical or asymmetrical crossovers. FREQUENCY: The VSXTM 26 is a very powerful tool and as such the frequency points are independent, allowing over-lapping or under-lapping as the system may require. When downloading the upgrade from the web place it in a folder: VSX26/firmware. Audio Channels LED metering 3 inputs/6 outputs 2 inputs/6 outputs RTA Mic input can be summed with Line inputs. [. . . ]