User manual PEAVEY XD 2

[. . . ] . . 15 . 16 . 20 . 22 . 22 . 25 . 27 . 29 . 30 . 30 . 33 Operation and Configuration . Printing using the Bluetooth Interface . The LCD screen (Wireless LAN Model Only) . Adjusting Printing for Non-Separate Labels . [. . . ] Locate the RS-232C interface port cover (1) and lift it up to expose the port. 2. Plug one end of the RS-232C cable (2) firmly into the port. Make sure that the arrow mark on the connector of the RS-232C cable matches with the arrow mark by the side of the printer's port. Plug the other end of the RS-232C cable to the corresponding RS-232C connector of the computer or hand-held terminal. For information on the host device RS-232C connector, refer to the relevant instruction manual. 40 Printing using the IrDA Interface 1. Place the printer 20 cm away from the IrDA port of the computer or hand-held terminal. Adjust the printer position so that the center of its IrDA filter projects a 30° conical area which contains the IrDA transceiver of the computer or hand-held terminal. · The IrDA communication range is limited to 5. 9 to 7. 9 inches (15 to 20 cm). · The usable range may vary depending on the usage environment, or the capabilities of other IrDA devices. · Communication is compromised by direct sunlight or ambient light. In such a case, block the strong light from entering the IrDA filter, or reduce the distance between the two IrDA ports. 41 Printing using the Wireless LAN Interface To print using the Wireless LAN model, you need to have a properly configured wireless LAN set up. The next step is to configure the printer to share the same network settings in order to establish communication. When you are printing non-separate labels and you have torn the labels at a wrong place, stop the printing and follow the instructions on the next page to correct the print job. 46 Adjusting Printing for Non-Separate Labels When printing on a continuous label roll (non-separate), if you tear off a label at the wrong place, proceed as follows. Interrupt printing on the computer, or by pressing the PRINT key (1) to take the printer OFFLINE. Press the FEED button (1) to feed a label. 3. When the feeding stops, tear off the label correctly by pulling the label in the direction of the arrow shown in the 47 diagram. The label is now aligned properly for printing to resume. 4. Press the PRINT button to return to the on-line state (STATUS LED lights green). You can now resume the print job. 48 The Label Dispensing mode You can choose to dispense labels in Continuous Mode and Dispense Mode. In either mode, test printing and online printing are available. Configuring Dispense mode Dispense Mode can be set to Auto Print or Manual Print, as described below. Type Auto Print Description Prints one label after receiving data and waits for peeling. After the label is peeled off, the printer automatically prints the next label. Prints one label after receiving data and goes off-line. [. . . ] Note: The speed varies depending on print duty and environment of use. LP440: 128 mm wide x 88 mm high x 73 mm deep, excluding belt clip LP441: 119 mm wide x 88 mm high x 64 mm deep, excluding belt clip Dimensions Weight, with battery pack Power supply (Battery) LP440: 14. 3 oz. (390 g) Prints 4 rolls of thermal labels with full charge. (equivalent of 18. 9 yards (48 m) Continuous printing is permitted (provided print duty is 16% or less. ) 0. 0025 to 0. 0075-inch (0. 064 to 0. 190 mm). [. . . ]