User manual PEAVEY XR 2012

[. . . ] Mention of software products manufactured by other companies does not necessarily constitute endorsement by the manufacturer . While all reasonable efforts have been made to make this document as accurate and helpful as possible, we make no warranty of any kind, expressed or implied, as to the accuracy or completeness of the information contained herein. The most up-to-date drivers and manuals are available from the web site: http://www. okiprintingsolutions. com Trademark Information Oki is a registered trademark of Oki Electric Industry Company Ltd. Other product names and brand names are registered trademarks or trademarks of their proprietors. 2 Contents Safety, Warnings and Cautions . [. . . ] Turn the printer upside down and unlatch the battery compartment cover. 28 2. Align the battery pack so that its metal terminals (1) are facing the printer and the tab (2) on the battery is up, then insert the battery until it snaps in place. 3. Close the battery cover. 29 Removing the Battery Pack Important!: Remove the battery pack only when the printer is turned off. Do not remove the battery while the STATUS LED is on. Otherwise, the information stored in the printer may not be updated. Press the POWER button to turn the printer off. POW ER PR INT FE ED 2. Turn the printer upside down and open the battery cover (1). 30 3. Push aside the gray latch (2) in the compartment and pull out the battery (3). 4. Close the battery cover. 31 Powering the Printer using the Optional AC Adapter The optional AC adapter can be used to power the printer instead of the supplied battery pack. Remove the cover of the printer's DC input jack (1) and connect the AC adapter's DC output terminal (2) to it. 2. Connect the AC adapter to the wall outlet (3) and turn on the power. Turn the label roll lightly by hand and confirm that it rotates smoothly. Otherwise, paper may not be fed correctly during operation. 39 7. Confirm that the leading edge of the label is outside the printer by at least 10 mm, then close the cover. m 10 m Note: When using linerless labels, press the FEED button to feed a piece of label and pull the label upward to cut it along the perforation. If the label becomes jammed, retry the label setting procedure. Push the dispenser unit forward so that it covers the red platen roller. 40 Operation and Configuration Turning the Printer ON POW ER PR INT FE ED 1. When the STATUS LED (2) lights green, release the button Turning the Printer OFF POW ER PR INT FE ED 1. When the STATUS LED (2) goes off, release the button. 41 Performing a Test Print Important!: A low battery condition may affect the print quality. Make sure the printer is running on AC or on a full battery during a test print. Users can perform test prints to evaluate the print quality and also diagnose problems. Press the POWER button to turn the printer off. Press and hold the FEED button (1), then press the POWER button (2) to turn the printer on. POW ER PR INT FE ED The printer enters the test mode. 42 3. [. . . ] Double-check Dip Switch settings (See "Interface Specifications"). Replace the print head. Paper guide is positioned incorrectly. Roller is dirty. No printing RS-232C cable connection is faulty. IrDA Interface is faulty. Bluetooth/WLAN interface is faulty. [. . . ]