User manual PEAVEY XR 600F

[. . . ] Intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION: To reduce the risk of electric shock, do not remove cover. WARNING: To prevent electrical shock or fire hazard, do not expose this appliance to rain or moisture. Before using this appliance, read the operating guide for further warnings. [. . . ] When this switch is depressed the lower EQ / PWR AMP 2 remains connected to the main bus (mono). The upper EQ / PWR AMP 1 then carries the monitor signal only, creating an entire PA and monitor mixing system in one small, easy-to-carry package. And this change is accomplished without a single patch cord!This control also sets the monitor level going to the power amp when in Main/Monitor mode (see System Mode #21). This control sets the Main level going to the power amp when in Main/Monitor mode and also in the Main/Main mode (see System Mode #21). A good starting position for this control is the center detent position (12:00). When phantom power is switched on, make sure that any channel you are plugging a mic into is turned down in both the main and monitor mixes. Otherwise, there will be a loud pop in the PA. It is best to plug all mics into their respective channels with the phantom power switched off. This reduces noise in the PA and reduces the chances of the mic being damaged. If phantom power is used, do not connect unbalanced microphones or other devices that cannot handle this voltage to the XLR inputs. (Some wireless receivers may be damaged; consult their manuals for compatibility. ) The line input 1/4" jacks are not connected to the phantom supply, and are safe for all inputs (balanced or unbalanced). An unbalanced-to-balanced impedance converter, such as the Peavey 5116 or a Peavey 1:1 Interface Adapter, can also be used to isolate a mic from phantom voltage. MONITOR OUTPUT: This 1/4" jack provides an output from the monitor mix to supply external power amp/monitor combinations. The level of this signal is determined by the Monitor Level control. The level of this signal is determined by the Main Level control. POWER AMP INPUTS: Plugging into these jacks allows the user to go directly into the Graphic Equalizer, then into its respective power amplifier channel. POWER LED: The power on LED indicator will light when the unit is powered. A/C POWER INLET: This is the receptacle for an IEC line cord, which provides AC power to the mixer/amplifier. Connect the line cord to this connector to provide power to the unit. Damage to the equipment may result if improper line voltage is used (see line voltage marking on unit). [. . . ] Power supply cords should always be handled carefully. Never walk or place equipment on power supply cords. Periodically check cords for cuts or signs of stress, especially at the plug and the point where the cord exits the unit. 11 The power supply cord should be unplugged when the unit is to be unused for long periods of time. [. . . ]