User manual PEAVEY XR 600G

[. . . ] For more information on other great Peavey products, go to your local Peavey dealer or online at www. Intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION: To reduce the risk of electric shock, do not remove cover. WARNING: To prevent electrical shock or fire hazard, do not expose this appliance to rain or moisture. [. . . ] pad: Attenuates the input signal by -25 dB. If you notice distortion from a particular channel or if the channel becomes loud very quickly, try engaging this switch. In addition to increasing the dynamic range, the channel input can now accommodate a higher input level before clipping occurs. This may be necessary when close-mic'ing a loud guitar amp or drum kit. Level & Signal/Clipping Indicator: Sets the signal level sent to the main mix. The bi-color LED is green when signal is present and red when clipping occurs. if clipping occurs , turn the channel Level control (4) down. If the channel clips when turning the Level control up only slightly, try engaging the Pad switch (3). Mon (monitor): Controls the level of each channel signal (pre-EQ) that is added to the monitor mix. low EQ: A shelving type of active tone control that varies the bass frequency levels (±15 dB at 70 Hz). This will add depth to thin-sounding signals or clean up muddy ones. Too much of this EQ can give you a booming bottom end. This control is designed to remove noise or add brilliance to the signal depending on the quality of the source. Efx: This control varies the level into the digital effects processor bus, adjusting signal level from the individual channel to the digital processor. The inputs are summed to mono, allowing a stereo source to be input into these channels. In critical situations, two mono line sources can be connected to one input. Line In: This pair of RCA phono jacks accepts a stereo input (nominally -10 dBV) from the output of a tape deck, CD player or other similar device. the signal is placed on the main channel as well as the monitor mix. Line Out: This pair of RCA phono jacks provides a signal for the recording inputs of a stereo tape, CD player or other similar device. Take a break, mute channels 1­6 without changing the mic level settings. Just remember to unmute before beginning your performance. You'll find enough features in the Master Section of the XR600G to fit most sound reinforcement situations. [. . . ] Monitor Output: This 1/4" jack provides a signal from the monitor mix, after the graphic EQ, for an external amplifier/speaker system. The level is determined by the channel monitor and master monitor controls. effects Defeat: This 1/4" jack accepts an on/off 1/4" footswitch (Peavey Part # 00051000) to defeat effects of both the Main and Monitor mixes. Phantom Power Switch: This switch, when depressed, applies 48 VDC to all input XLR connectors to power microphones that require phantom power. [. . . ]