User manual PEAVEY XR 696F

[. . . ] For more information on other great Peavey products, go to your local Peavey dealer or online at www. Intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION: To reduce the risk of electric shock, do not remove cover. WARNING: To prevent electrical shock or fire hazard, do not expose this appliance to rain or moisture. [. . . ] Line In: This stereo pair of RCA phono jacks accepts a stereo input (nominally -10 dBV) from the output of a tape deck, CD player or other similar device. the signal is placed on the Left and Right channels as well as the monitor mix. Line Out: This stereo pair of RCA phono jacks provides a signal for the recording inputs of a stereo tape, CD player or other similar device. You'll find enough features in the Master Section of the XR 684F/XR 696F to fit most sound reinforcement situations. Our audacious engineers (these guys are nuts) have been busy adding features to these products that you won't find in any other powered mixer. Adjust the two parameter controls (Time/Size and Color/Tone) to your desired settings. When you are satisfied with the new settings, push the Store button once. the corresponding LED will start blinking. Now, twist the Preset Selector knob to one of the four locations provided and push the Store button again. This action stores your settings and the LED stops blinking. When recalling any one of these four userdefined locations, keep in mind that the parameter settings are stored internally and may differ from where the actual knobs are physically set. Store LED: This yellow indicator blinks to indicate that you are in the Store mode. ) Effects Peak LED: This red LED illuminates to indicate 6 dB of headroom before the signals being sent to the effects circuit are clipped. Ideally, you want this LED to light only occasionally. An occasional blink indicates that your levels are set optimally. When using a delay setting, this control adjusts the feedback or depth. efx to Mon: This control adjusts the amount of effects signal sent to the monitor mix. This allows effects to be heard from the stage via the monitors. Important: To get the best performance from your new Peavey XR Powered mixer, you must let the Feedback Ferret "learn" each new room using the simple setup procedure described below. The Ferret, Peavey's award-winning feedback eliminator, is actually built into the XR 684F/XR 696F. the Ferret automatically applies 16 digital filters to control feedback within your setup. If you're operating your powered mixer in stereo mode, you can apply the Ferret to both the Left and Right channels. [. . . ] Power Amplifier Specifications: Power Section: 1200 SC Module with DDT Rated Power: 600W program into 4 ohms, both channels driven/500W RMS into 4 ohms, both channels driven 475W program into 8 ohms, both channels driven/360W RMS into 8 ohms, both channels driven Frequency Response: 20Hz­20kHz +0dB, -1dB @ rated power Total Harmonic Distortion (THD): <0. 01% @ rated output @ 1kHz DDT Dynamic Range: Greater than 26dB DDT Maximum Distortion: Below 0. 5% THD for 6dB overload Below 1% THD for 20dB overload Hum and Noise: 97dB below 500W Damping Factor: Greater than 100 @ 1kHz, 4 ohms Input Sensitivity: 1. ** Minimum input level (sensitivity) is the smallest signal that will produce nominal output (4dBu) with channel and master controls set for maximum gain. [. . . ]