User manual PEAVEY XR 800F

[. . . ] Intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION: To reduce the risk of electric shock, do not remove cover. WARNING: To prevent electrical shock or fire hazard, do not expose this appliance to rain or moisture. Before using this appliance, read the operating guide for further warnings. [. . . ] In Rotary Speaker setting, this adjusts the speed of the speaker rotation. (While using a delay, this control adjusts the feedback or depth. This control allows effects to be heard from the stage via the monitor. When feedback occurs, this system will automatically indicate the graphics slider to use to lessen or eliminate feedback. (NOTE: These LEDs illuminate with any audio signal, not just during feedback. They are designed for 12 dB of cut and 12 dB boost. They are connected directly to their power amplifier inputs. the signal sent to each equalizer is determined by the System Mode Switch (20). SYSTEM MODE SWITCH: This switch is used to configure the XR 800F as either a stereo or dual mono amplifier. The XR 800F is shipped from the factory in the default setting of Left Main to the upper EQ and Right to the lower EQ. When this switch is depressed it switches the lower EQ to (mono) PA Left + Right. The upper EQ then becomes the Monitor signal only, creating an entire PA and Monitor mixing system in one small, easyto-carry package. And this change is accomplished without a single patch cord!POWER LED: The power on LED indicator will light when the unit is powered. SIGNAL LEVEL METERS: Displays overall level of either the L and R signals or the Mon and L+R (mix) signals. the System Mode Switch determines which mode the meter will operate in. Red Clip LEDs are located at the top of each meter to indicate clipping. A clipped signal may damaged your speakers. When in Main/Monitor mode [see System Mode Switch (20)] the Monitor Fader controls the monitor signal present at the Left/Mon Power Amp Output (4). The Left and Right Faders would then control the L/R Mix present at the Right/L+R Power Amp Output (4). Most features are found on all channels, however, there are some differences in channel's 7, 8 and 9. Therefore, this section is divided to properly indicate those differences. [. . . ] Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. Unplug this apparatus during lightning storms or when unused for long periods of time. Servicing is required when the apparatus has been damaged in any way, such as powersupply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. [. . . ]