User manual PEEKTON PKM 600

[. . . ] When installed indoors, unplug the AC Power Adapter from the wall outlet when the PKM 600 is not to be used for an extended period of time. If batteries are installed, set the Power On/Off-VOL control to the Off position to prevent unintentional battery discharge, or remove the batteries. To avoid possible damage to the Shuttle Boom Box caused by battery leakage, it is recommended that the batteries be removed when the Boom Box is not being used for an extended period of time. Do not install or place the PKM 600 on an inclined or unstable surface. [. . . ] AUX Jack: Accepts an audio input signal from an external audio device. When using the AUX audio input, turn the Shuttle off to preserve battery power. Adjust the volume level of the external audio device to obtain an audio output from the PKM 600. The volume 7 control on the external audio device should be set to mid-range. AUDIO OX 1 2 3 4 5 6 3. PHONES Jack: Accepts a stereo headphone jack to provide private listening capability for the Boom Box. VOLUME +/- Pushbuttons: Increase or decrease the volume of the audio output signal from the PKM 600. To increase the volume level, press the + pushbutton; to decrease the volume level, press the - pushbutton. NOTE: When the PNP3 shuttle is installed, the Volume buttons on the Remote Control unit will control the audio output of the Boom Box. Power On/Low Battery LED: The LED lights green when the Power On/Off pushbutton is pressed to apply power to the PKM 600. In addition, the LED will light red to alert the user that the batteries are nearly discharged. This condition may cause degraded performance of the PKM 600. Because of the orbiting characteristics of the Sirius Satellites, the strength of the received signal may change over -7- 128-7266A 7 of 12 time. In most cases however, the signal should be available continuously. If you experience a loss of signal or audio, reposition the antenna inside the home or outside as necessary. Antenna Placement Considerations The antenna should be placed on a relatively flat surface whenever possible. When outdoors, the antenna may be left in its mount atop the Boom Box provided no overhead obstructions are present. Plug the antenna into the ANT connector on the back of the PKM 600. Leave the antenna in place on the Boom Box, or remove the antenna from its mount, uncoil the antenna lead, and place it at the preferred location inside or outside the home. If no audio i s heard, move the antenna to different positions on the surface until an audio output is heard. This is the desired antenna position and, if indoors, should be marked. After determining the optimum position, turn off PKM 600 and Shuttle power. Disconnect the power adapter from the wall outlet receptacle (if indoors) and disconnect the antenna cable. d. [. . . ] (2670 Grams) 128-7266A 9 of 12 Maintenance Periodic Inspection The PKM 600 Boom Box should be inspected periodically for external damage. At least once every 30 days of use, perform the following checks: 1. Inspect the 20-pin Shuttle connector for loose, bent or broken pins, misalignment, etc. ; make sure the SAT connector is intact and exhibits no apparent damage. Check the VOL control for freedom of motion without binding of any kind. [. . . ]