User manual PEG PEREGO BOOK PLUS S

[. . . ] Attach the basket to the two buttons at the front (fig_d) and 4 fasten the eyelets at the rear onto the buttons as shown in the figure, with the upper one going from the top towards the bottom (fig_e) and the lower one going from the inside towards the outside (fig_f ). 5 FIXED OR SWIVELING FRONT WHEELS: Lift the levers to prevent the wheels from swiveling (fig_a) and lower them to allow the wheels to swivel (fig_b). On uneven surfaces, the wheels should be set to their fixed position. 6 BRAKE: Press the lever down to apply the brake on the chassis and lift it to release the brake. [. . . ] Ensure the buttons are fastened on the rear of the backrest. If this is not the case, fasten them now (fig_a). To open the hood, pull it towards you; to close the hood, push it backwards. The hood may only be used as a parasol if the backrest is not fully reclined. In this case, open the double slider zipper (fig_b) and unfasten the hood buttons on the rear of the backrest. The hood comes with a loop from which to dangle baby’s favorite toy (fig_c). 1 8 COVER: put on the cover, and fasten it underneath (fig_a) and on the sides of the footboard. For the baby carriage version, move the footboard up and place the cover over the front bar (fig_b), fastening it to the buttons of the hood (fig_c). For the stroller version, move the footboard down, insert the cover underneath the front bar (fig_d) and fix it in place. 19 BABY SAFE: pull the Baby Safe system out from under the leg rest (fig_a), attach it to the seat (fig_b), fit the front bar (fig_c), unbutton the fabric covering at the side and then attach the Baby Safe system to the sides of the armrests (fig_d). a fitted Baby Safe system is shown in Figure E. 2 0 RAIN CANOPY: position the rain canopy on the stroller (fig_a) and insert the two lateral loops over the hood buttons (fig_b). 2 1 Secure the rain canopy by attaching the elastic loop to the rear uprights (fig_a) or to the front uprights (fig_b), according to the seat position. 2 2 FOLDING UP: to fold up the seat press the outer sides towards the inside (fig_a) and fix in place with the fastener (fig_b). 2 3 FOLDING UP: The chassis can be folded up without the seat, with the seat facing the person pushing (recline the backrest before folding it) or with the seat facing forward. To fold the stroller, it is best to set the front wheels to their fixed position and close the hood (if fitted). Position the handlebar as shown in fig_a and lift the levers on the two uprights on the sides (fig_b). Pull the inner handle on the base (fig_c), keep hold of it, lift it (fig_d) and swing the handlebar forward until the chassis is folded. 2 4 Once the chassis is folded up, check that it has been secured with the clips on either side (fig_d) and fasten them if necessary. The chassis is freestanding when folded up (fig_e). If necessary, it can be made even more compact by removing the rear wheels. Pull the pin out and remove the wheel, as in fig_f. [. . . ] CLEANING THE RAIN CANOPY: wash with a sponge and soapy water; do not use detergents. CLEANING FABRIC PARTS: brush fabric parts to remove dust and wash by hand at a maximum temperature of 30°C; do not wring; do not use chlorine bleach, do not iron; do not dry clean; do not apply solvent-based stain removers and do not dry in a tumble dryer. Peg Pérego can make changes at any time to the models described in this publication for technical or commercial reasons. PEG-PÉREGO AFTER-SALES SERVICE ACCESSORY If any parts of the item get lost or damaged, only use genuine Peg Pérego spare parts. [. . . ]