User manual PEG PEREGO GAUCHO ROCK IN

[. . . ] 27 · Fit the horn unit into the hole in the middle of the steering wheel. 5 Volt AA batteries (not supplied with the vehicle) into the compartment, taking care to position the positive and negative poles correctly. Close the battery compartment cover and screw into place. 29 · Insert the wire from the antenna and the radio into their appropriate housing on the dashboard, making sure to place them the right way up, as shown in the figure. [. . . ] Battery polarity must be observed when connecting battery to wiring. Do not make direct contact between battery terminals, as this can cause an explosion or fire. Charge batteries in a well ventilated area away from sources of heat and flammable materials. ⷠExhausted batteries are to be removed from the vehicle. ⷠDo not place the batteries near clothing to avoid damage. Avoid direct contact with the electrolyte, protect your hands. place battery in a plastic bag and follow directions listed below. IF ELECTROLYTE COMES IN CONTAC WITH SKIN OR CLOTHING Flush with cool water for at least 15 minutes. Do not throw used batteries in your regular, house hold trash. Dispose of the old batteries in an approved dumping station; contact your local environmental protection agency office for further information. See the back cover of this instruction manual for a list of service centers. Peg Perego is at the consumer's service, meeting every need in the best way possible. This is why our customers' opinions are so important and valuable to us. We would be very grateful if you would kindly fill in the CUSTOMER SATISFACTION QUESTIONNAIRE after using one of our products. Please note any observations or suggestions you may have on the questionnaire. Place from bumper on body and tighten four screws as shown in the drawing. 2 · Take out the 2 bulbs placed on the bottom of the rear part of the vehicle (in the area of the shock absorbers). Put the tool box on the bonnet and fix it as shown in the figure. Align steering wheel column holes with steering wheel: nut fits into haxagon hole, bolt into round hole. 11 · Fit the removable seat cover as shown in the figure. Detach parts A and C of the Roll-Bar; join A to B; 16 · Screw the net down to the body. ATTENTION: Check the fastening studs to be sure they are tight. [. . . ] Never use the vehicle on steep slopes or near steps or stairs. This vehicle is not suitable for use on public highways. ⷠChildren should always wear shoes when riding in or driving a ride-in/ride-on vehicle. ⷠDo not allow children to place their hands, feet or any part of their body, clothing or other articles near the moving parts while vehicle is in operation. [. . . ]