User manual PEG PEREGO PRIMO VIAGGIO TRIFIX

[. . . ] E N• Spare parts available in different colours to be specified when ordering. € The "Primo Viaggio Tri-Fix K" car safety seat is attached to the car using a three-point seat belt. • “Universal” category. € The "Adjustable Base" is installed in the car using the three-point seat belt and remains in the car ready for use. [. . . ] € Do not use this car safety seat after five years from the date of production indicated on the structure. The natural ageing of the materials may mean that it is no longer compliant with standards. € The use of the safety seat for premature infants born at less than 37 weeks could cause respiration problems for the infant seated in the safety seat. It is advisable to seek medical advice before leaving the hospital. € Do not use accessories not approved by the manufacturer or by the competent authorities. € Do not use the reclined cradle once your child can sit unaided. € This reclined cradle is not intended for prolonged periods of sleeping. € It is dangerous to use this reclined cradle on an elevated surface, e. Instructions for use 1• "Primo Viaggio Tri-Fix K" is provided with the Ganciomatic System for in-car attachment and detachment from an "Isofix Base" or "Adjustable Base" and outside the vehicle to Peg-Pérego strollers and chassis. To attach "Primo Viaggio Tri-Fix K" (to an "Isofix Base", "Adjustable Base", or Peg-Pérego stroller or chassis) align it with the attachment points and push down with both hands until it clicks into place. 2• To release "Primo Viaggio Tri-Fix K" (from an "Isofix Base", "Adjustable Base", or Peg-Pérego stroller or chassis) raise the handle to the transport position, push the lever on the backrest upwards and at the same time raise the safety seat. 3• To engage the safety harness, put the two shoulder straps on and insert them into the buckle of the crotch strap until they click into place. 4• To release the safety harness press the red button on the crotch strap buckle. 5• To slacken the harness, insert a finger into the seat slot (fig. A), press the metal button and at the same time pull the shoulder straps upwards with the other hand (fig. 6• To tighten the shoulder straps on the child, pull the central adjustment strap towards you as shown in the figure, taking care not to over-tighten the straps and leaving minimal room to manoeuvre. 7• The shoulder straps of the safety harness and the “Side Impact Protection” headrest can be adjusted simultaneously to 5 different heights so as to follow the growth of the child. To adjust the height, press the rear height adjustment button (on the safety seat backrest) and at the same time raise or lower to the required position, ensuring that it clicks into place. Slacken the shoulder straps before adjusting the height of the safety harness and the headrest. 8• The correct position of the headrest is defined by the correct position of the shoulder straps. The child’s shoulders must be just above the point of passage of the shoulder straps. 9• The seat is equipped with an anatomic padded cushion for newborns, to be removed when the child is older. [. . . ] To remove the strap, simply slip it through the opening in 17 Serial numbers 26• The following information can be found under the front of the seat of the Primo Viaggio Tri-Fix K : product name, production date and serial number. 27• The approval label can be found under the back of the seat of the Primo Viaggio Tri-Fix K. In the event of problems with the product, these details will be of use to customers. Peg Pérego is at the disposal of its customers and consumers to ensure that all their demands and queries are fully satisfied. [. . . ]