User manual PENTAX OPTIO 50L

[. . . ] FCC STATEMENT (For customers in USA) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Use the four-way controller ( ) to select [Drive Mode], then press the button. Mode1 Focus Drive Mode AE Metering Mode2 Mode3 Std. OK: Exit : MENU 2 / 3 4. Use the four-way controller ( ) to select [HS Continuous], then press the button. To exit the menu, press the MENU button. The indicator is displayed on the monitor screen. Press the shutter release button halfway to lock the focus. Press the shutter release button to capture a sequence of images. OK : Drive Mode Std. HS Continuous Auto Bracket Exit : MENU 2/3 In High Speed Continuous mode, the flash mode will be set to Flash Off automatically. EN-40 Auto Bracket In this mode, the camera automatically changes the exposure within a set range to take three shots after you press the shutter release button once. Auto Bracket settings can be combined with exposure compensation settings to extend the adjustment range. Rotate the mode dial to , , , , or and turn your camera on by pressing the Power switch. Press the MENU button, then use the four-way controller ( ) to select the [Mode2] menu. Use the four-way controller ( ) to select [Drive Mode], then press the button. Use the four-way controller ( ) to select [Auto Bracket], then press the button. To exit the menu, press the MENU button. The indicator is displayed on the LCD monitor screen. Press the shutter release button to capture the three images. Drive Mode Std. HS Continuous Auto Bracket OK : Exit : MENU 3/3 In Auto Bracket mode, the flash mode will be set to Flash Off automatically. EN-41 Selecting the Metering Mode You can select the metering mode that sets which part of the subject to measure to determine the exposure. Rotate the mode dial to , , , or and turn your camera on by pressing the Power switch. Press the MENU button, then use the four-way controller ( ) to select the [Mode2] menu. Use the four-way controller ( ) to select [AE Metering], then press the button. Mode1 Focus Drive Mode AE Metering Mode2 Mode3 Std. OK : Exit : MENU 3 / 3 4. Use the four-way controller ( ) to select the desired metering mode, then press the button. [ Center-weighted]: Averages the light metered from the entire frame, but gives greater weighted to the subject matter at the center. [ Spot]: The exposure is determined by the small area in the center of the screen only. [. . . ] Shipping charges are to be borne by the owner. EN-82 If your PENTAX was purchased outside of the country where you wish to have it serviced during the warranty period, regular handling and servicing fees may be charged by the manufacturer's representatives in that country. Notwithstanding this, your PENTAX returned to the manufacturer will be serviced free of charge according to this procedure and warranty policy. In any case, however, shipping charges and customs clearance fees to be borne by the sender. To prove the date of your purchase when required, please keep the receipt or bills covering the purchase of your equipment for at least a year. [. . . ]