User manual PENTAX OPTIO S5Z

[. . . ] PENTAX Corporation 2-36-9, Maeno-cho, Itabashi-ku, Tokyo 174-8639, JAPAN (http://www. pentax. co. jp/) PENTAX Europe GmbH (European Headquarters) Julius-Vosseler-Strasse, 104, 22527 Hamburg, GERMANY (HQ - http://www. pentaxeurope. com) (Germany - http://www. pentax. de) PENTAX U. K. Limited PENTAX House, Heron Drive, Langley, Slough, Berks SL3 8PN, U. K. (http://www. pentax. co. uk) PENTAX France S. A. S. 12/14, rue Jean Poulmarch, 95106 Argenteuil Cedex, FRANCE PENTAX Benelux B. V. [. . . ] Pictures are taken continuously while the shutter release button is pressed. 4 Taking Pictures 1 2 Press the four-way controller (2) in Capture mode to display j on the LCD monitor. Press the shutter release button halfway. The focus frame on the LCD monitor will light green when the camera is in focus. 12 5/24/2005 12:00 3 Press the shutter release button fully. Pictures are taken continuously while the shutter release button is pressed. Shooting stops when you take your finger off the shutter release button. · You can continue shooting until the SD Memory Card or the builtin memory is full. · The interval will vary according to the [Recorded Pixels] and [Quality Level] settings. · The flash will not discharge in Continuous Shooting mode. · Continuous shooting is not available for Movie or Panorama Assist mode. · The focus, exposure and white balance are locked with the first image. 67 1 Using the Zoom to Change the Subject Size You can use the zoom to change the size of the subject and take pictures in Tele or Wide mode. 4 Taking Pictures 68 1 Press the zoom button in Capture mode. x Tele: makes the subject bigger. w Wide: makes the subject smaller. 198 When the digital zoom function is disabled, you can take pictures at up to three times magnification using the optical zoom. When the digital zoom function is enabled, you can further enlarge the subject to a maximum magnification equivalent to 12 times. Zoom bar Digital zoom range 198 When digital zoom is enabled Saving the Zoom Position 1p. 96 You cannot use the optical zoom when taking movies. Setting the Digital Zoom The digital zoom is set to O(On) in the default settings. To take pictures using only the optical zoom, set the digital zoom to P(Off). 1 2 3 4 Press the MENU button in Capture mode. The [A Rec. Mode] menu appears. Use the four-way controller (23) to select [Digital Zoom]. Use the four-way controller (45) to select O (On)/P (Off). Press the shutter release button halfway. The camera is ready to take pictures. Rec. Mode EV Compensation ±0. 0 Movie Digital Zoom Aux. AF Light Instant Review 1 sec Memory MENU Exit 4 Taking Pictures You cannot use the digital zoom in Special Effect mode. Saving the Digital Zoom Function Setting 1p. 96 69 6, 7, 8 2, 3, 4, 5 1 Taking Time-lapse Movies This mode lets you take movies at a delayed frame rate so that when you play the movie back, the action appears speeded up. 4 Taking Pictures 70 1 2 3 4 5 Press the MENU button in Movie mode. The [A Rec. Mode] menu appears. Use the four-way controller (23) to select [Movie]. Press the four-way controller (5). The Movie screen appears. Use the four-way controller (23) to select [Time-lapse Movie]. Press the four-way controller Movie (5). Time-lapse Movie x20 A pull-down menu appears. Use the four-way controller (23) to change the time-lapse setting. You can choose from [Off], [×2], [×5], [×10] and [×20]. MENU x10 x5 x2 Off Cancel OK OK 6 7 Press the shutter release button halfway. The camera is ready to record a time-lapse movie. Press the shutter release button fully. Recording of a time-lapse movie starts. The selected time-lapse setting appears on the LCD monitor. 07:34 x10 5/24/2005 14:25 8 Press the shutter release button fully. Stops recording movie. [. . . ] Always obtain a quotation for the service charge, and only after you accept the quoted service charge, instruct the service station to proceed with the servicing. 8 Appendix 161 · This warranty policy does not affect the customer's statutory rights. · The local warranty policies available from PENTAX distributors in some countries can supersede this warranty policy. Therefore, we recommend that you review the warranty card supplied with your product at the time of purchase, or contact the PENTAX distributor in your country for more information and to receive a copy of the warranty policy. 8 Appendix The CE Mark is a Directive conformity mark of the European Community. 162 For customers in USA STATEMENT OF FCC COMPLIANCE This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. [. . . ]