User manual PEUGEOT V-CLIC BROCHURE

[. . . ] 6 Petrol . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Check and change engine oil . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Check and change coolant. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Battery / Fuse . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Call a doctor immediately. A B C ! For best operation of your engine, use only non-leaded petrol 95 or 98 GB C - Oil Filler neck of engine oil housing. 4-stroke engine : - Do not use 2-stroke engine oil - Never exceed the maximum level on the peephole on the engine - Important note: Read page 17 of this manual - Do not add any additives to the lubricant - Tool kit * The tool kit consists of : - Double-bladed screwdriver - Spark plug wrench - Shock absorber adjustment wrench * According to the model 7 Checking and changing engine oil (Frequency : see maintenance booklet) - Checking engine oil level. Engine cold or at a standstill for at least 10 minutes, - Put the vehicle onto its central stand on level ground - Check the oil level contained in the engine housing using the peephole located on the lower right hand side of the engine; the level should always be above the minimum level but never above the maximum level. The oil level is topped up through the filler neck recommends A Important The difference between the max. Use of the vehicle if the oil level is less than the min. level, may cause irremediable damage to the engine. 4T SPECIAL 10W40 UNIFLO 10W40 - Changing the engine oil Changing the engine oil must be carried out when the engine is at least warm in order to facilitate oil flow. Warning The engine oil, housings, cylinder head and exhaust pipe can reach very high temperatures, be careful of the risk of burning. Used engine oil must be disposed of at a purpose-built recycling point. - Put the vehicle onto its central stand on level ground, - Place a container with a capacity of at least 1. 5 litres under he oil change hole - Loosen and remove the oil change plug and filter - Let the oil run into the container - Wipe the oil change plug C and filter D with a clean cloth and change the tightness seal E - Retighten the plug with the filter and a seal in place in the housing A - Filling / Topping up B maxi mini - Slowly fill the engine housing via the oil fill hole with new 4stroke oil A - Do not exceed the max. level of the sight glass B - Make sure that there is no leak around the oil change plug - Check the oil level in the engine housing as described in the level checking procedure - After having run the engine for a few minutes, top up if necessary - Capacity with change of filter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1, 25 litre - Capacity without change of filter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1, 0 litre Warning - Never exceed the maximum level of the sight glass on the engine. W5W(T10) All lamps are 12 volts See your dealer or distributor immediately if one of the lamps is not working properly. B - Changing the bulbs FRONT : Headlight : - Remove the 4 screws A from the front panel - Tip the fairing forward - Remove the 4 headlight fixation screws B - Change the bulb To adjust the headlight : unclip the container in the bottom of the LH side glove compartment and turn the adjustment screw C in order to set the vertical orientation. Indicators : - Remove the screw E and the lens - Change the bulb C D E E REAR : Rear light : - Remove the 2 screws D and the lens - Change the bulb Indicators : - Remove the screw E and the lens - Change the bulb NUMBER PLATE : - Remove the screw F - Remove the 2 support screws from the bulb holder cover - Change the bulb F 11 Starting the engine - With the electric starter For safety reasons : - Put the scooter on its central stand The electric starter will not work unless you squeeze the left brake lever. To start the engine : - Turn the ignition key A to the position - Squeeze the brake lever - Press the starter button B - Release the button when the engine starts When the engine is cold, keep the throttle closed. Precautions Never run the engine in a closed room. Exhaust gases contain carbon monoxide and toxic gases. A Stopping the engine and parking After stopping the scooter : - Only turn off the ignition when the engine is at idling speed - Put the ignition key A to - Put the vehicle on its stand - Remove the key to prevent risks of theft - Parking on the stand - Avoid driving or parking on easily inflammable materials (eg : dry leaves, . . . ) The stand is fitted with a lever to park the scooter easily. - Move to the left side of the scooter - Hold the scooter by its handlebar and the grab handle at the back of the saddle - Push the stand lever with your right foot while pulling the scooter backwards with the handlebars and the saddle's grab handle B - Placing on side stand * Bearing in mind that the isde stand is equipped with an automatic lift mechanism, be careful when carrying out different operations on the vehicle. Caution Make sure that the vehicle is stable on its stand so that it cannot fall over and possibly cause any body wound or any damage to the scooter. * According to the model 12 Running in and driving - Running Running in has an essential influence on correct operation, power and long life of your engine. During the first 500 kilometers, never run your scooter at maximum speed, particularly when cold or going down hill. The vehicle will obtain its maximum performances only after the running in time. B - Driving your scooter With the engine running on its stand : - Keep the rear (left) brake lever A on to lock the rear wheel - Do not open the throttle - Lift the stand - Get onto your scooter - Free the rear wheel (release the brake lever) B - Accelerate to start (turn the throttle gradually) - Turn the throttle in the opposite direction to decelerate Caution You must lock the rear wheel before you lift the stand. If the rear wheel is turning you could lose control of the scooter when it touches the ground. - Do not accelerate roughly (quickly opening and closing the throttle) - Do not leave your scooter unattended with the engine running A Maintenance (Frequency : see maintenance manual) - Mission box Changing the gearbox oil is not absolutely necessary. [. . . ] All the elements required for starting the engine are conditioned by the recognition of an ELECTRONIC CODE generated by the red key, called the MASTER KEY, which means the scooter can not be used simply by changing the ignition key. All the so-called safety-related items are not available in After-Sales. However, if the rider can prove that he is the owner of the vehicle, our Peugeot dealer can order all the items of this system. A LED warning light blinks on the instrument panel 4 to show that the system is actuated (dissuasive effect). [. . . ]