User manual PFAFF TIPMATIC 1027

[. . . ] Removing the carrying case cover To lift off the carrying case cover, fold the handle to the rear, as indicated byan arrow. Opening the hinged top cover Also fold the handle toward the rear. On Model 1027 a stitch chart is found on the inside of this cover (A). Removing and opening the swing-out arm Reach under the swing-out arm with your left hand (B), swing it out toward the left (C) and lift it out (D). [. . . ] Inserting the bobbin Insert the filled bobbin into the bobbin case so that the thread unreels toward the back (A>. Then draw the thread into slot B and under the spring into eye C. 7 Inserting the bobbin case Pull out latch K and push the bobbin case onto stud B, making sure slot A is up. Release the latch and lightly press against the bobbin case to make sure it has snapped into place. Drawing up the bobbin thread Hold the needle thread a little taut. Turn hand wheel 32 toward you until the needle movesdownand upagainandthetake-up lever is up. Pull the bobbin thread out of the needle hole and lay both threads toward the left and back under the sewing foot. 8 Presser bar lifter Lever 42 has three positions: A = The sewing foot is raised. (Before you remove the work, turn the hand wheel toward you to raise the needle and take-up lever 52. ) B = The sewing foot is raised further for inserting extra-thick materials. C Thread cutter The thread cutter is an oblique slot located at the back of the presser bar. Utility- and stretch-stitch combinations, model 1027 The various stitch combinations are shown in the chart on the inside of the hinged top cover. For example, if you want to sew an elastic blindstitch, push buttons 1 5 and 1 6, select a stitch length between 1 and 4. This stitch can also be sewn with model 1025. Selecting the needle position for straight stitching Left needle position: push button 20 Central needle position: push button 1 0 Right needle position (model 1 027): push buttons 11 and 1 2. L 6 ri J L Dropping the machine feed Open free arm cover 48. The feed dog is dropped (for embroidering, darning, etc. ) For sewing , push the drop-feed control toward A. Changing the needle Raise the needle bar. Then hold the needle, loosen screw A and pull the needle out downwards. Insert a new System 1 30/705 H needle (with the flat side of its shank facing toward the back) and push it up as far as it will go. Twin needles with a needle distance of 1. [. . . ] buttonhole settings Push button 1 9 (A). Regulate the stitch density in the buttonhole range of the stitch length control (B). Insert the filler cord as follows (C): Place it over the rear lug of the foot, pull it taut and clamp it in front lug D. As you sew, arrow E moves along scale F. [. . . ]