User manual PHILIPS 109B1099

[. . . ] About This Electronic User's Manual About This Electronic User's Manual About This Guide · Other Documents You May Need · Notational Descriptions About This Guide This electronic user's guide is intended for anyone who uses the Philips 109B Color Monitor. It describes the monitor's features, setup, operation and all other information, which is the same exact information described in our printed version. The sections are as follows: q q q q q q q q Safety and Troubleshooting Information provides tips and solutions for common problems, and other related information you may need. About This Electronic User's Manual gives overview of what information are included as well as notation icon descriptions and other documentation you can refer to. [. . . ] To completely switch off the equipment, the power supply cable must be removed from the power supply socket, which should be located near the equipment and easily accessible. A protection mark "B" confirms that the equipment is in compliance with the protection usage requirements of standards PN-93/T-42107 and PN-89/E-06251. file:///E|/manual/english/109B/safety/regs/regulat. htm (8 of 13)2004-10-19 NSH 01:46:37 Regulatory Information RETURN TO TOP OF THE PAGE North Europe Information Placering/Ventilation VARNING: FÖRSÄKRA DIG OM ATT HUVUDBRYTARE OCH UTTAG ÄR LÄTÅTKOMLIGA, NÄR DU STÄLLER DIN UTRUSTNING PÅPLATS. file:///E|/manual/english/109B/safety/regs/regulat. htm (9 of 13)2004-10-19 NSH 01:46:37 Regulatory Information Placering/Ventilation ADVARSEL: SØRG VED PLACERINGEN FOR, AT NETLEDNINGENS STIK OG STIKKONTAKT ER NEMT TILGÆNGELIGE. Paikka/Ilmankierto VAROITUS: SIJOITA LAITE SITEN, ETTÄ VERKKOJOHTO VOIDAAN TARVITTAESSA HELPOSTI IRROTTAA PISTORASIASTA. Plassering/Ventilasjon ADVARSEL: NÅR DETTE UTSTYRET PLASSERES, MÅ DU PASSE PÅ AT KONTAKTENE FOR STØMTILFØRSEL ER LETTE Å NÅ. RETURN TO TOP OF THE PAGE BCIQ Notice (Taiwan Only) file:///E|/manual/english/109B/safety/regs/regulat. htm (10 of 13)2004-10-19 NSH 01:46:37 Regulatory Information RETURN TO TOP OF THE PAGE Ergonomie Hinweis (nur Deutschland) Der von uns gelieferte Farbmonitor entspricht den in der "Verordnung über den Schutz vor Schäden durch Röntgenstrahlen" festgelegten Vorschriften. Auf der Rückwand des Gerätes befindet sich ein Aufkleber, der auf die Unbedenklichkeit der Inbetriebnahme hinweist, da die Vorschriften über die Bauart von Störstrahlern nach Anlage III ¤ 5 Abs. 4 der Röntgenverordnung erfüllt sind. Damit Ihr Monitor immer den in der Zulassung geforderten Werten entspricht, ist darauf zu achten, daß 1. Reparaturen nur durch Fachpersonal durchgeführt werden. nur original-Ersatzteile verwendet werden. bei Ersatz der Bildröhre nur eine bauartgleiche eingebaut wird. Aus ergonomischen Gründen wird empfohlen, die Grundfarben Blau und Rot nicht auf dunklem Untergrund zu verwenden (schlechte Lesbarkeit und erhöhte Augenbelastung bei zu geringem Zeichenkontrast wären die Folge). Der arbeitsplatzbezogene Schalldruckpegel nach DIN 45 635 beträgt 70dB (A) oder weniger. ACHTUNG: BEIM AUFSTELLEN DIESES GERÄTES DARAUF ACHTEN, DAß NETZSTECKER UND NETZKABELANSCHLUß LEICHT ZUGÄNGLICH SIND. RETURN TO TOP OF THE PAGE End-of-Life Disposal Your new monitor contains materials that can be recycled and reused. Specialized companies can recycle your product to increase the amount of reusable materials and to minimize the amount to be disposed of. file:///E|/manual/english/109B/safety/regs/regulat. htm (11 of 13)2004-10-19 NSH 01:46:37 Regulatory Information Please find out about the local regulations on how to dispose of your old monitor from your local Philips dealer. RETURN TO TOP OF THE PAGE Information for UK only WARNING - THIS APPLIANCE MUST BE EARTHED. Important: This apparatus is supplied with an approved moulded 13A plug. To change a fuse in this type of plug proceed as follows: 1. Fit new fuse which should be a BS 1362 5A, A. If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate 3pin plug fitted in its place. If the mains plug contains a fuse, this should have a value of 5A. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5A. Note: The severed plug must be destroyed to avoid a possible shock hazard should it be inserted into a 13A socket elsewhere. file:///E|/manual/english/109B/safety/regs/regulat. htm (12 of 13)2004-10-19 NSH 01:46:37 Regulatory Information How to connect a plug The wires in the mains lead are coloured in accordance with the following code: BLUE - "NEUTRAL" ("N") BROWN - "LIVE" ("L") GREEN & YELLOW - "EARTH" ("E") 1. The GREEN AND YELLOW wire must be connected to the terminal in the plug which is marked with the letter "E" or by the Earth symbol or coloured GREEN or GREEN AND YELLOW. The BLUE wire must be connected to the terminal which is marked with the letter "N" or coloured BLACK. The BROWN wire must be connected to the terminal which marked with the letter "L" or coloured RED. Before replacing the plug cover, make certain that the cord grip is clamped over the sheath of the lead - not simply over the three wires. RETURN TO TOP OF THE PAGE file:///E|/manual/english/109B/safety/regs/regulat. htm (13 of 13)2004-10-19 NSH 01:46:37 Other Related Information Other Related Information Safety Precautions and Maintenance · Troubleshooting · Regulatory Information · Information for Users in the U. [. . . ] China Phone: (024)-23900452 Fax : (024)-23900452 XIAN No. 6-9 yan ta road south part, 710061 Xian, P. R. China Phone: (029)-5520833 Fax : (029)-5534655 GUANGZHOU No. 15-17 long kou dong road, tian he district, file:///E|/manual/english/warranty/warcic. htm (6 of 12)2004-10-19 NSH 02:06:36 Consumer Information Centers 510070 Guangzhou, P. R. [. . . ]