User manual PHILIPS 14PT3685

[. . . ] Introduction When setting up your television set for the first time, we advise you to use the quick installation guide included below. Please read the following instructions carefully to familiarise yourself with all the features available on your set. We hope our technology meets entirely with your satisfaction. Table of Contents Installation Presentation of the television set . 6 Other settings on the INSTALLATION menu . [. . . ] The number and sound mode are displayed for a few moments on the screen. To compose a two-figure number using the numerical keys , add the 2nd figure before the hyphen disappears. The title of certain programmes appears for a few moments at the bottom of the screen. To view a programme that has been locked, enter the confidential code (see p. Radio mode Use the P or keys to select the FM radio stations (from 1 to 40). The number, frequency and sound mode are displayed for a few seconds before the screen goes blank. List of radio stations In radio mode, the key dislays or clears the list of radio stations. You can then use the or keys to change the station. To change the page, select <> (using ) then press or to display the previous or following pages. You can also modify how the stations are stored (see p. 7). Screen information TV or radio mode Press to display for a few seconds or clear the programme number, time and sound mode. In radio mode, the frequency of the station is also displayed. Permanent display of the programme number Press for five seconds to activate the permanent display of the programme number. Press once to cancel. 9 TV light æ Use the  Use the The feet and clock of the television set are luminous and backlit. key on the remote control to switch the lighting on and off . keys to increase or decrease the intensity of the 3 levels of lighting. Note: the lighting controls are independent of the television controls (it may be in TV, radio or standby mode). However the lighting does not operate when the set is switched off using the on-off key. Setting the clock The television set is equipped with an analogue clock on the front of the set. Automatic r eset: The time is automatically reset, each time the set is switched on, using teletext information taken from TV programme 1. · If it does not have teletext, the time will not be updated. · If the appliance has been disconnected from the mains, the hands on the clock will move through 360° when switched on. The television set is equipped with a backup system which stores the time when the appliance is disconnected from the mains. To manually set the clock: æ Press SET ALARM on the remote control. The CLOCK menu is displayed on the screen.  Press once to select SET CLOCK. ê Enter the current time using or clock is updated a few seconds later. . The time on the analogue ® Press SET ALARM again to exit the menu. Changing the time: For countries which change their clocks twice a year (summer time, winter time), the clocks are reset automatically using the teletext information taken from programme 1. However, the time is only updated when the television set is switched on. 10 Adjusting picture and sound Adjusting the picture Press (the set must be in TV mode). . Use and to adjust: BRIGHTNESS, COLOUR, CONTRAST, SHARPNESS, TINT, CONTRAST+ NOISE RED. · SHARPNESS: alters the crispness of the image. [. . . ]  Enter the number of the page required. ê Press then the coloured key of your choice. The page is stored. ® Repeat steps  and ê for the other coloured keys. From now on, when you consult teletext, your favourite pages appear in colour at the bottom of the screen. To get back to the normal subject headings, press . To remove these settings, hold for 3 seconds. 14 Connecting other appliances Video recorder Video recorder (only) Connect as shown using a good quality euroconnector cable. If your video recorder does not have a euroconnector socket, the only connection possible is via the aerial cable. [. . . ]