User manual PHILIPS 150P2D74

[. . . ] Philips 150P2E/150P2D Electronic User's Manual file:///D|/Grace/150P2/english/150p2e/index. htm [8/9/2001 11:25:13 AM] Safety & Troubleshooting Safety and Troubleshooting Information Safety Precautions and Maintenance · Installation Locations · FAQs · Troubleshooting · Regulatory Information · Other Related Information Safety precautions and maintenance WARNING: Use of controls, adjustments, or procedures other than those specified in this documentation may result in exposure to shock, electrical hazards, and/or mechanical hazards. Read and follow these instructions when connecting and using your computer monitor: q Unplug the monitor, if you are not going to use it for an extensive period of time. q Unplug the monitor, if you need to clean it with a slightly damp cloth. Wiping the screen with a dry cloth is possible when the power is off. However, never use alcohol, solvents, or ammonia-based liquids. q q q q q q q q q q q Consult a service technician if the monitor does not operate normally when following the instructions in this manual. [. . . ] Check that the signal cable is properly connected to the graphics board or PC. q q q Push the Auto button. Eliminate the vertical bars using the Clock Adjustment of VIDEO NOISE in OSD Main Controls. Horizontal flicker appears q q Push the Auto button. Eliminate the horizontal bars using the Phase Adjustment of VIDEO NOISE in OSD Main Controls. file:///D|/Grace/150P2/english/150p2e/safety/saf_troub. htm (1 of 2) [8/9/2001 11:25:43 AM] Troubleshooting q The screen is too bright or too dark q Adjust the contrast and brightness in OSD Main Controls. (The backlight of the LCD monitor has a fixed life span. When the screen becomes dark or begins to flicker, please contact your dealer. If an image remains in the screen for an extended period of time, it may be imprinted in the screen and leave an after-image. This usually disappears after a few hours This is characteristic of liquid crystal and is not caused by a malfunction or deterioration of the liquid crystal. The after-image will disappear after a set amount of time The remaining dots are normal characteristic of the liquid crystal used in today's technology. An after-image appears An after-image remains after the power has been turned off. Green, red, blue, dark, and white dots remains q q For further assistance, refer to the Consumer Information Centers list to contact your local Philips distributor. RETURN TO TOP OF THE PAGE file:///D|/Grace/150P2/english/150p2e/safety/saf_troub. htm (2 of 2) [8/9/2001 11:25:43 AM] Regulatory Information Regulatory Information TCO '99 Information · TCO Environmental Requirements · Energy Star Declaration · Federal Communications Commission (FCC) Notice (U. S. Only) · Commission Federale de la Communication (FCC Declaration) · EN 55022 Compliance (Czech Republic Only) · VCCI Class 2 Notice (Japan Only) · MIC Notice (South Korea Only) · Polish Center for Testing and Certification Notice · North Europe Information · BSMI Notice (Taiwan Only) · Ergonomie Hinweis (nur Deutschland) · Philips End-of-Life Disposal · Information for UK only Safety and Troubleshooting · Troubleshooting · Other Related Information · Frequently Asked Questions (FAQs) TCO '99 Information Congratulations!You have just purchased a TCO '99 approved and labeled product!Your choice has provided you with a product developed for professional use. Your purchase has also contributed to reducing the burden on the environment and also to the further development of environmentally adapted electronics products. Why do we have environmentally labeled computers? In many countries, environmental labeling has become an established method for encouraging the adaptation of goods and services to the environment. The main problem, as far as computers and other electronics equipment are concerned, is that environmentally harmful substances are used both in the products and during their manufacture. Since it is not so far possible to satisfactorily recycle the majority of electronics equipment, most of these potentially damaging substances sooner or later enter nature. There are also other characteristics of a computer, such as energy consumption levels, that are important from the viewpoints of both the work (internal) and natural (external) environments. Since all methods of electricity generation have a negative effect on the environment (e. g. acidic and climate-influencing emissions, radioactive waste), it is vital to save energy. Electronics equipment in offices is often left running continuously and thereby consumes a lot of energy. What does labeling involve? This product meets the requirements for the TCO'99 scheme which provides for international and environmental labeling of personal computers. The labeling scheme was developed as a joint effort by the TCO (The Swedish Confederation of Professional Employees), Svenska Naturskyddsforeningen (The Swedish Society for Nature Conservation) and Statens Energimyndighet (The Swedish National Energy Administration). Approval requirements cover a wide range of issues: environment, ergonomics, usability, emission of electric and magnetic fields, energy consumption and electrical and fire safety. file:///D|/Grace/150P2/english/150p2e/safety/regs/regulat. htm (1 of 11) [8/9/2001 11:25:45 AM] Regulatory Information The environmental demands impose restrictions on the presence and use of heavy metals, brominated and chlorinated flame retardants, CFCs (freons) and chlorinated solvents, among other things. [. . . ] Industrial Vallejo C. P. 02300, -Mexico, D. F. Phone: (05)-3687788 / 9180050462 Fax : (05)-7284272 file:///D|/Grace/150P2/english/warranty/warcic. htm (2 of 8) [8/9/2001 11:26:29 AM] Consumer Information Centers PARAGUAY Philips del Paraguay S. A. Avenida Artigas 1519 Casilla de Correos 605 Asuncion Phone: (021)-211666 Fax : (021)-213007 PERU Philips Peruana S. A. Customer Desk Comandante Espinar 719 Casilla 1841 Limab18 Phone: (01)-2412890 Fax : (01)-2412913 URUGUAY Ind. Philips del Uruguay S. A. [. . . ]