User manual PHILIPS 15C04204-77C

[. . . ] IBM, IBM PC and Power PC are registered trademarks of International Business Machines Corporation. 2 Safety precautions and maintenance x Disconnect the monitor from the mains supply if the monitor is not to be used for an extended period of time. x Do not attempt to remove the back cover, as you will be exposed to a shock hazard. The back cover should only be removed by qualified service personnel. [. . . ] Do not expose the monitor to rain or excessive moisture to avoid the risk of shock or permanent damage to the set. x Do not use alcohol or ammonia based liquid to clean the monitor. If necessary, clean with a slightly damp cloth. Disconnect the monitor from the mains supply before cleaning. x Consult a service technician if the monitor does not operate normally when operating instructions of this manual are followed. E N Package Your PHILIPS 105S package includes the following items: · The monitor · Pedestal · Power cord · Interface cable (flying-in) · Win95 driver disk · MAC adapter (option) End of life disposal Your new set contains materials which can be recycled and reused. Specialized companies can recycle your product to increase the amount of reusable materials and to minimize the amount of materials to be disposed of. Please inform yourself on local regulations on disposal of your old set. 3 E N Installation Important: Please refer to the user's manuals of your computer and video adapter to make sure these equipments are properly installed and configured before installing the monitor. Positioning / Ventilation x Avoid exposing the monitor to direct sunlight, stoves or any other heat sources. x To prevent overheating, make sure that the ventilation openings of the monitor are not covered. x Keep away from any magnetic objects, such as speakers, electric motors, transformers, . . . etc. V-Size : to adjust the vertical amplitude of the image. Second level of the function pads: Trapezoid Pincushion Recall : to correct the trapezoid distortion of the image. : to correct the barrel distortion of the image : to recall original factory preset mode Remarks: 1. When pressing any function pad, the "Shift" LED will flash once to indicate the function has been selected. Once the limit of the adjustable range has been reached, the shift LED will flash continuously. 8 Adjustment The monitor is pre-set with 6 modes for optimal display size and centering as indicated in the following table: Resolution Horizontal Vertical (dots x lines) Freq. (KHz) Freq. (Hz) 640 x 400 31. 5 70 640 x 480 31. 5 60 640 x 480 43. 3 85 800 x 600 46. 9 75 800 x 600 53. 7 85 1024 x768 60. 0 75 E N Mode VGA VGA VESA /85 VESA/75 VESA/75 VESA/75 Remark Non-interlaced Non-interlaced Non-interlaced Non-interlaced Non-interlaced Non-interlaced (A) User mode: (10 modes) The set will save the user's setting parameters automatically. After 10 seconds of key-pad inactivity, the LED will flash twice to indicate the parameters being saved. (at second level) 9 E N (B) Power Management Signalling Power Management Definition VESA DPMS MODE ON VIDEO Active H-SYNC V-SYNC Yes No Yes No Yes Yes No No POWER SAVING STATES POWER USED < 90 Watts < 15 Watts < 15 Watts < 8 Watts POWER SAVING(%) 0% > 80 % > 80 % > 90 % Stand-by Blanked Suspend Blanked OFF Blanked Note: The video will be blanked and the power LED color will change into following colors whenever the monitor goes into power management status. Green LED light - "Normal" operation Yellow LED light - "Stand by" or "Suspend" mode Amber LED light - "OFF" mode This monitor is Energy Star compliant when used with a computer equipped with DPMS. AS AN ENERGY STAR PARTNER, PHILIPS HAS DETERMINED THAT THIS PRODUCT MEETS THE ENERGY STAR GUIDELINES FOR ENERGY EFFICIENCY. Remark: The transition time from "on" mode to any power down mode will take around 5 seconds. [. . . ] The recovery time from "stand by" or "suspend" mode to "ON" mode will take around 5 seconds. 10 Technical information (I) General: Picture tube : 15 inch (38. 1 cm), 90° deflection, nonglare, black matrix, light transmission 57%, phosphor P22 medium short, dotted pitch 0. 28 mm. E N Screen area Recommended Display Area: 270 mm (H) x 202 mm (V) Maximum Display Area : 283 mm (H) x 215 mm (V) Line (Horizontal) frequency : 30 - 60 KHz (automatically) Raster (Vertical) frequency : 50 - 120 Hz (automatically) Mains voltage : 100 - 240 VAC , 60 - 50 Hz Power consumption : 70 watt nominal, 90 watt max. Maximum dot rate : 79 MHz Video input signal : 0. 7 Vp-p linear / 75 Ohm Sync type : Separate H, V, TTL level Sync Polarity : Positive or Negative Pedestal : Tilt - 5° forward, 15° backward; swivel - 90° leftward or rightward. Unit dimension (W x H x D) : 369 x 396 x 393 mm Net weight : 13 Kg Operating condition Temperature : 0° C to 40° C Humidity : 20% to 80% Storage condition Temperature : -25° C to 70° C Humidity : 20% to 95% DDC1/DDC2B : VESA standard (II) Compatibility: . [. . . ]