User manual PHILIPS 15L5082Q99

[. . . ] The casing cover should be opened only by qualified service personnel. Keep the monitor out of direct sunlight and away from stoves or any other heat source. Remove any object that could fall into the vents or prevent proper cooling of the monitor's electronics. Do not block the ventilation holes on the cabinet. [. . . ] The specification page provides detailed safety standards data. More information is provided in the Regulatory Information chapter. RETURN TO TOP OF THE PAGE file:///D|/Grace/150P2/english/150p2m/safety/saf_faq. htm (8 of 8) [6/19/2001 3:30:08 PM] Troubleshooting Troubleshooting Safety and Troubleshooting · FAQs · Common Problems · Imaging Problems · Regulatory Information · Other Related Information This page presents problems that can be corrected by the user. If the problem still exists after these possible solutions, contact your nearest Philips dealer. Common Problems Having this problem?No Picture (Power LED not lit) Check these items q q Make sure the Power cable is plugged to the wall and the back of the monitor. First, power button in front of the monitor should be in the OFF position, then press it to ON position again. Make sure the signal cable is properly connected to your computer. Check to see if the monitor cable has bent pins. The Energy Saving feature may be activated q No Picture (Power LED is amber or yellow) Screen says q q q q q q Make sure the monitor cable is properly connected to your computer. Check to see if the monitor cable has bent pins. Make sure the computer is turned on. Screen says q q q Make sure the vertical sync of input signal is within the range of 56 ~ 75 Hz. Change the refresh rate to 56~75Hz within 10 minutes. acidic and climate-influencing emissions, radioactive waste), it is vital to save energy. Electronics equipment in offices is often left running continuously and thereby consumes a lot of energy. What does labeling involve? This product meets the requirements for the TCO'99 scheme which provides for international and environmental labeling of personal computers. The labeling scheme was developed as a joint effort by the TCO (The Swedish Confederation of Professional Employees), Svenska Naturskyddsforeningen (The Swedish Society for Nature Conservation) and Statens Energimyndighet (The Swedish National Energy Administration). Approval requirements cover a wide range of issues: environment, ergonomics, usability, emission of electric and magnetic fields, energy consumption and electrical and fire safety. file:///D|/Grace/150P2/english/150p2m/safety/regs/regulat. htm (1 of 11) [6/19/2001 3:30:10 PM] Regulatory Information The environmental demands impose restrictions on the presence and use of heavy metals, brominated and chlorinated flame retardants, CFCs (freons) and chlorinated solvents, among other things. The product must be prepared for recycling and the manufacturer is obliged to have an environmental policy which must be adhered to in each country where the company implements its operational policy. The energy requirements include a demand that the computer and/or display, after a certain period of inactivity, shall reduce its power consumption to a lower level in one or more stages. The length of time to reactivate the computer shall be reasonable for the user. Labeled products must meet strict environmental demands, for example, in respect of the reduction of electric and magnetic fields, physical and visual ergonomics and good usability. Below you will find a brief summary of the environmental requirements met by this product. The complete environmental criteria document may be ordered from: TCO Development SE-114 94 Stockholm, Sweden Fax: +46 8 782 92 07 Email (Internet): development@tco. se Current information regarding TCO'99 approved and labeled products may also be obtained via the Internet, using the address: http://www. tco-info. com/ RETURN TO TOP OF THE PAGE Environmental Requirements Flame retardants Flame retardants are present in printed circuit boards, cables, wires, casings and housings. Their purpose is to prevent, or at least to delay the spread of fire. [. . . ] Centro de Informações ao Consumidor R. andar Phone: 0800-123-123 Fax : (0xx11) 3141-1580 CHILE Philips Chilena S. A. box 2687Santiago de Chile Phone: (02)-730 2000 Fax : (02)-777 6730 COLOMBIA Industrias Philips de Colombia S. A. -Division de Servicio CARRERA 15 Nr. 104-33 Bogota, Colombia Phone: (01)-9800-9-18971 (toll free) Fax : (01)-619-5377 MEXICO Consumer Information Centre Norte 45 No. 669 Col. [. . . ]