User manual PHILIPS 16907-87-16

[. . . ] If in doubt call your electric provider. Outdoor antennas should be grounded with an approved lighting arresting device. Height or other restrictions on antennas may apply to your installation depending on your proximity to an airport, or local ordinances. Take the time to plan your installation procedure. [. . . ] Do NOT work on a wet, snowy or windy day or if a thunderstorm is approaching. If the antenna assembly starts to fall, get away from it and let it fall. Remember that the antenna mast and cable are all excellent conductors of electrical current. do NOT install the antenna by yourself. Be sure that there are two other people available for help. If any part of the antenna should come in contact with a power line . Call your local power company immediately. DON'T TOUCH THE PERSON IN CONTACT WITH THE POWER LINE, or you too can become electrocuted. Instead, use a DRY board, stick, or rope to push or pull the victim away from the power lines and antenna. If he has stopped breathing, immediately administer cardiopulmonary resuscitation (CPR) and stay with him. The completed assembly should look like figure C. Attach the cable to the F connector on the underside of the unit and slide weather protection boot over the connection. As previously noted the power injector must be placed in-line between the antenna and before any splitter or additional devices. Connect the coaxial cable from the antenna to the F connector labeled ANT on the power injector. Connect the short lead from the power injector to the antenna input on your TV. Connect the power supply lead to the power injector, then plug the power supply into a 110/120 Volt AC receptacle. Safety Note - The power injector and power supply is for indoor use only!If your TV has separate inputs for UHF and VHF you will need to purchase a signal splitter that will separate the two different signals 2. If your TV has only two screw type antenna inputs you will need to purchase a 75 Ohm to 300 Ohm transformer. A note about coaxial cable ­ Your Mant 950 includes a 20 foot roll of RG-59 coaxial cable. [. . . ] A note about coaxial cable ­ Your Mant 950 includes a 20 foot roll of RG-59 coaxial cable. If you should find that this is not adequate for your needs we recommend for best possible signal integrity that you do not extend this cable. A better choice is to replace the cable with either RG-6 or RG-6 Quad Shield cable. Both of these cables are designed for minimal signal loss over longer cable runs. [. . . ]