User manual PHILIPS 21000050

[. . . ] 4 lt of water to be heated Electro-hydraulic steam dispensing interlock in the absence of the carafe, both during operating as well as stand-by phases. PLEASE NOTE: The Milk Island must be connected to a Saeco Talea coffee machine using the special connector. The Milk Island is not equipped with a connector suitable for connection to a conventional plug. Subject to engineering and manufacturing changes due to technological developments. [. . . ] All components described in this section may be washed in a dishwasher for home use. do not use sharp objects or harsh chemical products (solvents) for cleaning. Do not dry the machine and/or its components using a microwave and/or conventional oven. Wash the carafe with hot water and mild dish soap. Wash the emulsifying group with hot water and mild dish soap. It is advised to use a clean and properly dried valve. Warning: make sure that the cover is correctly inserted in the tube located inside the carafe. Keep the upper part angled onto the carafe, and slide the lower part of the handle underneath the carafe. 14 Warning: only use the milk carafe if intact and if all components are correctly assembled. At this point, firmly press so as to join both parts. The milk carafe is now assembled and ready for use. Clean the connector with a damp cloth. For thorough cleaning, fill the clean carafe with water and dispense steam (follow the instructions from step 2 to 6 on page 15). The carafe and the emulsifying group's components may be washed in a dish-washer for home use. Warning: Before removing the Milk Island, remove the water tank, drip tray and coffee grounds drawer, and empty the coffee bean hopper. Turn the coffee machine off and unplug the machine. To disconnect the Milk Island, gently position the coffee machine onto its right side, so the left side is up. Turn the coffee machine off and unplug the power cord from the socket. After having emptied the containers, delicately turn the machine onto one side. Push the release button, and remove the base from the coffee machine. 6 Return the coffee machine to its upright position, and replace all components that were previously removed. Using a coin, lock the cover by turning it as shown in the figure. [. . . ] In case of failure, faults or a suspected fault after a fall, immediately unplug the Milk Island from the machine (see removing the Milk Island). Repairs must only be carried out by an Authorized Service Centre. All liability for damages caused by works not carried out in a professional manner, is declined. This product complies with EU Directive 2002/96/EC. [. . . ]