User manual PHILIPS 21PT135B

[. . . ] § Repeat steps " to ( for each program you wish to renumber. Screen information To display / clear the program number and time remaining for the sleeptimer. Press the key for 5 seconds to activate permanent display of the number. VCR key * Keys not used Pre-set sound Used to access a series of stored settings: Voice, Music, Theatre. [. . . ] The Mono indication is red when in forced position. The remote control is compatible with all VCRs using the RC5 standard. Teletext call Press the c key to call teletext, change to transparent mode and then exit. The summary appears with a list of items that can be accessed. If the channel selected does not broadcast teletext, the screen remain black. Selecting a page Enter the number of the page required using the 0 to 9 or @ P # keys (always 3 digits). The number is displayed top left, the counter turns and then the page is displayed. Repeat this operation to view another page. If the counter continues searching, the page is not transmitted. Direct access to the items Coloured areas are displayed at the bottom of the screen. This menu is used to store the programmes one at a time. Om du känner till det önskade programmets frekvens kan du skriva dess frekvensnummer direkt med knapparna 0 till 9. Liitännät Käytä television takaosassa olevaa euroliitäntää tai television etuosassa olevaa AV-liitäntää (jos se on saatavana). Positioning the television set Place your TV on a solid, stable surface, leaving a space of at least 5 cm around the appliance. To avoid accidents, do not put anything on the set such as a cloth or cover, a container full of liquid (vase) or a heat source (lamp). Poor reception The proximity of mountains or high buildings may be responsible for ghost pictures, echoing or shadows. in this case , modify the orientation of the aerial. No picture or no sound Have you connected the aerial socket properly?Press and hold down the "- and"+ keys on the TV set for 5 seconds to display the Country menu. Ȭ keys to select your country and validate with H. standby If the set receives no signal for 15 mins , it automatically goes into standby mode. To save power, your set is fitted with components that give it a very low power consumption when in standby mode (less than 3 W). [. . . ] If your dealer cannot help, ask at a main Post Office for the booklet "How to Improve Television and Radio Reception". mains connection Before connecting the TV to the mains , check that the mains supply voltage corresponds to the voltage printed on the type plate on the rear panel of the TV. If the mains voltage is different, consult your dealer. Fit new fuse which should be a BS1362 5A, A. [. . . ]