User manual PHILIPS 21PT4456

[. . . ] When setting up your television set for the first time, we advise you to use the quick installation guide included below. Please read the following instructions carefully to familiarise yourself with all the features available on your set. We hope our technology meets entirely with your satisfaction. Recycling The materials used in your set are either reusable or can be recycled. [. . . ] To watch a programme which has been locked you will now need to enter the confidential code; otherwise the screen will remain blank. When a locked programme is displayed, use the P keys to access other programmes (the keys are used to enter the code). Caution: in the case of encrypted programmes which use an external decoder, it is necessary to lock the corresponding EXT socket (and not the programme number). To change the confidential code Repeat stages æ - ê above, then: ® Select CHANGE CODE and enter your own 4-digit number. If you have forgotten your confidential code, enter the universal code 0711 twice. This function (only available on certain models) allows you to use your TV as an alarm clock. Important: the time is updated automatically each time the set is switched on using teletext information taken from programme 1. If programme 1 does not have teletext, the update will not take place. And enter the number of the programme required. Select START TIME and enter the time at which the set is to switch on. Ú Press to put the set into standby mode. The set switches off automatically after 4 hours if no further commands are given. Depending on the model, there are 2 different versions of the remote control. Brings up the previous or following programme. For direct access to programmes For a 2-digit programme number, the second digit must be entered before the dash disappears. On certain programmes, the title of the programme is displayed for a few seconds at the bottom of the screen. To view a programme which has been locked, you must enter the confidential code number (see p. Hold down for 5 seconds to permanently display the programme number. Press quickly to display or remove the programme number, the time and the sound mode (stereo models only). To access a series of settings: RICH (when the room is very light), NATURAL (optimum conditions), SOFT (when the room is very dark) and return to Volume Mute Smart sound controls Smart picture controls To call up or exit from the menus. The menus disappear automatically after 30 seconds if no further command is given. The key allows the picture to be enlarged vertically to get rid of the black bands around cinema-format films. [. . . ] If your video recorder does not have a euroconnector socket, the only connection possible is via the aerial cable. You will therefore need to tune in your video recorder test signal and assign it programme number 0 (see manual store, p. Video recorder with decoder Connect the decoder to the second euroconnector on the video recorder. You can then record scrambled transmissions. [. . . ]