User manual PHILIPS 220BW9CB

[. . . ] Philips LCD Monitor Electronic User's Manual Safety Precautions and Maintenance FAQs Troubleshooting Regulatory Information Other Related Information Safety and Troubleshooting Information Safety precautions and maintenance WARNING: Use of controls, adjustments or procedures other than those specified in this documentation may result in exposure to shock, electrical hazards and/or mechanical hazards. Read and follow these instructions when connecting and using your computer monitor: Operation: Keep the monitor out of direct sunlight and away from stoves or any other heat source. Remove any object that could fall into ventilation holes or prevent proper cooling of the monitors electronics. Do not block the ventilation holes on the cabinet. When positioning the monitor, make sure the power plug and outlet are easily accessible. [. . . ] Start - starts the 6-step color calibration sequence. Quick View loads the before/after images. To return to Color home pane, click the Cancel button. Enable color calibration - by default is on. If unchecked, does not allow for color calibration to happen, dimes out start and quick view buttons. Must have patent info in calibration screen. First color Calibration Screen: Previous button is disabled until the second color screen. Next goes to the succeeding target (6-targets). Cancel closes the UI and returns to the plug in page. SmartImage - Allows user to change setting for better display setting based on content. When Entertainment is set, SmartContrast and SmartResponse are enabled. Plug-Ins - Asset Management Pane will only be active when selecting Asset Management from the drop-down Plug Ins menu. Displays Assent Management information on Managment, Description, Serial Number, Current Timing, Domain Name, and Asset Management Status. To return to Plug-in home pane select the plug-in tab. Plug-Ins - Theft Deterence Pane will only be active when selecting Theft from the drop-down Plug Ins menu. To enable Theft Deterrence, clicking Enable Theft button brings up the following screen: User can enter PIN between 4 and 9 digits numbers only. After entering PIN, Accept button takes user to the pop-up dialog box on the following page. Does not require the display be attached to a different host to go into theft mode. Once a PIN is entered and accepted, the following dialog box appears: Click on No button takes user to the following screen. Click on Yes button takes user to secure web site landing page. After creating PIN, the Theft Deterrence pane will indicate Theft Deterrence Enabled and provide PIN Options button: Theft Deterrence Enabled is displayed. Disable Theft opens pane screen on next page. PIN Options button only available after user creates PIN, button opens secure PIN web site. Disable Theft button opens the following pane: After entering PIN, Accept button disables PIN. Cancel button opens up main Theft Deterrence pane, displaying Theft Deterrence Disabled. Entering incorrect PIN results in the following dialog box: Options>Preferences - Will only be active when selecting Preferences from the drop-down Options menu. On a non-supported display capable of DDC/CI, only the Help and Options tabs are available. Displays current preference settings. [. . . ] The hub isolates low speed ports from full speed signaling. A hub consists of two portions: the Hub Controller and Hub Repeater. The repeater is a protocolcontrolled switch between the upstream port and downstream ports. It also has hardware support for reset and suspend/resume signaling. [. . . ]